Garmin Personal Navigator GPS 45XL Owner's Manual & Reference page 63

Garmin gps-45xl personal navigator owner's manual & reference gps-45xl
Table of Contents

Advertisement

.Three optional cables are available to connect the GPS45XL to an
external power source or interface with another unit or PC:
• Cigarette Lighter Adapter— Allows connection to a 12- volt DC
cigarette lighter plug.
• Data Cross-Load Cable— Allows data transfer between GPS
38/40/45/45XL units.
• PC Kit Data Cable— PC interface cable with 9-pin 'D' serial data
connector.
The following interface formats are supported by the GPS 45XL for
driving three NMEA devices:
NMEA 0180
NMEA 0183 version 1.5
Approved sentences:
GPBWC, GPGLL, GPRMB, GPRMC, GPXTE, GPVTG,
GPWPL, GPBOD
Proprietary sentences:
PGRMM (map datum), PGRMZ (altitude), PSLIB
(beacon rec. control)
NMEA 0183 version 2.0
Approved sentences:
GPGGA, GPGLL, GPGSA, GPGSV, GPRMB, GPRMC,
GPRTE, GPWPL, GPBOD
Proprietary sentences:
PGRME(estimated error), PGRMM (map datum),
PGRMZ (altitude), PSLIB (beacon receiver control)
DGPS corrections are accepted on RTCM-104 v. 2.0 format. The
GARMIN GBR 21 is the recommended beacon receiver for use with
the GPS 45XL. Other receivers with the correct RTCM format may be
used, but may not correctly display status or allow tuning control.
(UNIT VIEW)
NMEA 0182
Appendix C
Introduction
Specifications,
Preface
Wiring,
&Battery
Replacement
The GPS 45XL comes with
4 AA alkaline batteries.
After approximately 12
hours of operation in nor-
mal mode or 20 hours of
operation in battery-saver
mode, the batteries will
need to be re p l a c e d .
R e c h a rgeable ni-cad or
lithium batteries may also
be used. Note that the bat-
tery level indicator is cali-
brated for alkaline batter-
ies, and ni-cad or lithium
batteries will only show bat-
t e ry life at partial scale.
To replace batteries:
Remove the battery cover
by turning the thumb loop
at the bottom of the unit 1/4
t u rn
counter- c l o c k w i s e .
Remove used batteries and
i n s e rt new batteries into
position. The battery pole
you can still see should
match the symbol marked
on the case. Replace and
secure the battery cover by
turning the thumb loop 1/4
turn clockwise.
59

Advertisement

Table of Contents
loading

Table of Contents