U.S. Range Salamander Broiler Installation And Service Manual page 11

INSTALLATION Continued
3 . Slide the salamander down into the support brackets
installed in step 2, see figure 2 . NOTE: On ranges with 2
space saver ovens, the center post must slide into the
center channels built into the back of the unit .
4 . Once the salamander is in place, fasten it to the unit on
both sides of the range with the provided #14B x 5/8 hex
washer head tapping screws .
PROVIDED
#14B x 5/8 HEX
WASHER HEAD
TAPPING SCREWS
5 . For center support, (detail II) re-insert screws removed in
step 1 or provided sheet metal screws as shown in detail
II and III, inserting screws for detail III through clearance
in back panel .
FOR 48" RANGES WITH
STANDARD OR CONVECTION OVENS
AND STORAGE
CLEARANCE
HOLE
SCREWS
REMOVED
IN STEP 1
PROVIDED
SHEET METAL
SCREW
2 SCREWS
REMOVED
IN STEP 1
Part # 4523974 (11/07)
DETAIL I
ALL 48" RANGES
INNER
HOLES
CLEARANCE
HOLE
DETAIL III
DETAIL II
FOR 48" RANGES WITH
2 SPACE SAVER OVENS
CLEARANCE
HOLE
SCREWS
REMOVED
IN STEP 1
3 PROVIDED
SHEET METAL
SCREWS
2 SCREWS
REMOVED
IN STEP 1
6 . Re-insert screws removed in step 1 though clearance hole
in back panel as shown:
CLEARANCE
HOLE
REMOVED
SCREW
DETAIL IV
ALL 48" RANGES
INNER
HOLES
CLEARANCE
HOLE
DETAIL III
DETAIL II
Page 11