Workpiece And Work Area Set Up; General Operating Instructions - Central Machinery 13" Bench Drill Press Owner's Manual & Safety Instructions

Workpiece and Work Area Set Up

1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
5. Make sure the table height and position
is set so that the drill travel range is
sufficient for the material to be drilled.
6. Make sure the work is securely clamped. That
is, held in a drill vise, or bolted to the table. Never
hold the material with your bare hands while
drilling. Severe personal injury may be caused if
the material is flung out of the operator's hand.
7. IF THE MATERIAL IS IRREGULARLY SHAPED and
cannot be laid flat on the table, it should be securely
blocked and clamped. Any tilting, twisting or shifting
will result not only in a roughly drilled hole but also
increases the chances of damage to the drill.
8. FOR FLAT WORK, lay the piece on to a
wooden base and clamp it down firmly against
the table to prevent it from turning.

General Operating Instructions

1. Bring the drill bit down with the Feed Knob to where
the hole is to be drilled.
Make minor workpiece alignment adjustments.
2. Plug the Power Cord into an electrical outlet.
3. Turn the Drill Press on.
4. Pull down on the Feed Knob and slowly
drill the hole into the workpiece.
Item 38142 For technical questions, please call 1-800-444-3353.
9. FOR SMALL MATERIALS that cannot be clamped
to the table, use a drill press vise. Make sure
the vise is clamped or bolted to the table.
10. WHEN DRILLING COMPLETELY THROUGH
WOOD, always position a piece of scrap wood
between the material and the table to prevent
splintering on the underside of the material as
the drill breaks through. The scrap piece of
wood must make contact with the left side of
the column. Securely clamp the other end of the
scrap wood to the table. Also, set the depth of
the drill so that the drill will not come in contact
with the table - or align the table so that the
hole in its center is in line with the drill bit.
Figure D: Bracing workpiece against column
WARNING! If the drill bit grabs and spins the workpiece,
do not attempt to stop the spinning with your hands.
Step back, and turn the drill press off. Wait for the
spindle to stop turning before dislodging the workpiece.
5. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children's reach.
Page 11