Using The Excalibur System; Arming Using The Transmitter - Omega Excalibur AL-1000-EDP Operation Manual

Feature #11 Alarm Duration
Factory Default Setting 30 Seconds
press "arm/lock" button to program
(
Options:
press "disarm/unlock" button to program
60 Seconds (
press "II" button to program
90 Seconds (
press "III" button to program
120 Seconds (
This feature allows four choices of the Alarm Duration, which is the period of time
for which the system sounding the siren (and/or horn, optionally) and flashes the
parking lights when it is triggered. Caution: Before lengthening the Alarm
Duration you should always check and determine if there are any local anti-
noise or nuisance ordinances in your area, to avoid the possibility of receiving
a violation citation.
Feature #12 Parking Light Illumination Upon Disarm
Factory Default Setting On
Option: Off
This feature affects the parking light operation when the system is disarmed. When
this feature is turned on, the parking lights flash once, and then turn back on for
external illumination for 30 seconds unless the ignition key is turned on during that
time. If this feature is turned off, the parking lights flash once only, and do not
illuminate. This feature only affects the Excalibur's parking light operation, and not
the interior light operation.
Feature #13 2nd Channel Also Disarms System
Factory Default Setting On
Option: Off
"2nd channel" is most commonly used to remotely open the vehicle's trunk, in
which case the alarm should also disarm. This feature, turned on, configures the
system to disarm when the 2nd channel is used. If turned off, the 2nd channel output
will still occur, with 2 chirps, but without the parking light flashes; and if armed, the
system will not disarm.
Feature #14 3 or 45 Second Arming Delay
Factory Default Setting 3 Seconds
( press "arm/lock" button to program
Options:
press "disarm/unlock" button to program
15 Seconds (
30 Seconds ( press "II" button to program
press "III" button to program
45 Seconds (
When the system is armed, whether by the transmitter or by an automatic feature,
)
)
)
press "arm/lock" button to program
(
press "disarm/unlock" button to program
(
press "arm/lock" button to program
(
( press "disarm/unlock" button to program
)
)
)
Page - 26

Using the Excalibur System

Your Excalibur system is designed to deter theft of both your vehicle and its
contents. "Arming" your system turns on the protection, disabling the vehicle's
starter and locking the doors. Once the system is Armed, any intrusion attempt will
)
Activate it, sounding the electronic "Psyren" psycho siren and flashing the parking
and interior lights to attract attention. The unique and patented "2-in-1" Psyren
psycho siren actually produces the sounds of two different sirens at once, ensuring
that it won't be ignored like all of the other "common" car alarms. Disarming the
system turns off the protection, unlocking the doors and turning on the parking and
interior lights, allowing lighted access to, and normal use of, the vehicle.
There are two methods of arming the Excalibur:
1- The first method is to use the transmitter, by pressing and releasing the
"arm/lock" button. The system must not already be armed or be in Valet Mode,
and the vehicle's ignition key must be off.
)
2- The second method is Last Door Arming, which configures the system to
) automatically arm itself every time you exit the vehicle. This method of arming
is programmable, and may be used or not used as desired.
Regardless of how it became armed, if the system is armed the Status Light flashes
in a slow, steady manner.
The system can always be armed from the transmitter if the ignition key is "off"
) and the system is not in the Valet Mode. To arm the system, exit the vehicle, close
)
all of the doors, and simply press and release the "arm/lock" button once.
The system's reaction: The parking lights will flash once, the siren will chirp
once and the Status Light will begin to flash, confirming that the system is armed.*
In addition, the doors will lock and the starter interrupt will engage to prevent any
attempt to start the vehicle. Your security system is now fully armed, and is ready
to respond if an intrusion attempt is detected.
The Excalibur system's separate "arm/lock" and "disarm/unlock" button
design allows repetitive operation- if already armed, pressing the "arm/lock" button
will simply rearm the system, and vice versa when pressing the "disarm/unlock"
button.
)
*The system is described in its most common and basic configuration, with
doorlocks connected, and the interior lights connected. Also, the vehicle horn
may used in place of, or in addition to, the system's electronic siren.

Arming Using the Transmitter

Page - 7