Starting And Stopping - Briggs & Stratton industrial plus 90000 series Manual

Table of Contents

Advertisement

WARNING
• Do not use pressurized
starting fluids.
• Vapors are flammable.
REWIND (MANUAL) STARTER
TO START ENGINE
OIL LEVEL
Shut-off valve
[1] Check oil level (see p. 8).
[2] Open fuel shut-off Valve
Stop switch
OFF
ON
[5] Move stop switch to ON
(if equipped).
TO STOP ENGINE
CAUTION: Do not stop
engine by moving choke
control
to
CHOKE.
Backfire, fire or engine
damage could occur.
STARTING AND OPERATING TIPS
♦ Store and fuel equipment in
level position.
♦ Use fresh fuel. (See Fuel.)
♦ Use correct type of oil for
expected starting temperature.
(See Oil.)
♦ Remove external equipment/
engine loads. (See equipment
operating instructions.)
[3] Move throttle to
1/4 TURN
FAST
COUNTER
CLOCKWISE
(if equipped).
Operate engine
with throttle in
FAST.
WARNING
• When starting engine,
pull cord slowly until
resistance is felt, then
pull rapidly.
Throttle
[1] Move throttle to SLOW,
then STOP
(if equipped).

STARTING AND STOPPING

♦ Periodically remove any debris
♦ After engine has started, let it
♦ For maximum performance and
Throttle
[4] Move choke lever to CHOKE.
Stop switch
[2] Push stop switch
to OFF
(if equipped).
9
buildup from the machine (See
Maintenance.)
warm up several seconds to
several minutes, depending on
outside temperature.
life, operate engine with choke
in RUN and throttle in FAST.
Choke
FULL CHOKE
POSITION
Once engine starts, gradually
move choke to RUN.
[6] Allow engine to
warm up.
If choke equipped:
Slowly adjust toward
RUN position. Wait
until
engine
runs
smoothly before each
choke adjustment.
Shut-off valve
1/4 TURN
CLOCKWISE
OFF
ON
[3] Close fuel
shut-off valve.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

90000 series

Table of Contents