Sign in today to find solutions:

Don't have an account? Sign up

Furuno GP-320B Operator's Manual

Furuno gps receiver user manual.

 
Back
OPERATOR'S MANUAL
GPS RECEIVER
GP-320B
MODEL
www.furuno.co.jp
Next page ->

Summary of Contents

  • Page 1

    Back OPERATOR'S MANUAL GPS RECEIVER GP-320B MODEL www.furuno.co.jp...

  • Page 3

    (http://www.eiae.org/) for the correct method of disposal. How to discard a used battery Some FURUNO products have a battery(ies). To see if your product has a battery, see the chapter on Maintenance. Follow the instructions below if a battery is used. Tape the + and - terminals of battery before disposal to prevent fire, heat generation caused by short circuit.

  • Page 4

    SAFETY INSTRUCTIONS CAUTION Confirm that the power supply voltage is compatible with the voltage rating of the equipment. Connection to the wrong power supply can cause fire or damage the equipment. NOTICE No one navigation device should ever be solely relied upon for the navigation of a vessel.

  • Page 5

    TABLE OF CONTENTS SYSTEM OVERVIEW ... iv EQUIPMENT LISTS ... vi 1. MOUNTING ... 1 2. WIRING ... 2 3. DEFAULT SETTINGS ... 6 4. TROUBLESHOOTING, BATTERY ... 7 SPECIFICATIONS ... SP-1 PACKING LIST OUTLINE DRAWING Declaration of Conformity...

  • Page 6

    SYSTEM OVERVIEW The GP-320B is a GPS receiver with WAAS (Wide Area Augmentation System) capability. WAAS, available in North America, is a provider in the worldwide SBAS (Satellite Based Augmentation System) navigation system. CBAS provides GPS signal corrections to SBAS users, for even better position accuracy, typically better than three meters.

  • Page 7

    Echo Sounder LS-6100 * = WAAS is inoperative. JUNCTION BOX This GPS receiver complies with Canadian standard RSS-210 (Low Power License-Exempt Radio communication Devices). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

  • Page 8

    EQUIPMENT LISTS Standard supply Name GPS Receiver GP-320B Optional equipment Name Cable Assembly MJ-A7SPF/SRMD-100 000-144-534 Mast Mounting Kit CP20-01111 Right Angle NO.13-QA330 Antenna Base L-angle Antenna NO.13-QA310 Base Handrail-mount NO.13-RC5160 Antenna Base Type Code No. ⎯ Type Code No. 004-365-780...

  • Page 9: Mounting

    • Select a location out of the radar beam. The radar beam will obstruct or prevent reception of the GPS signal. • The location should be well away from a VHF antenna. A GPS receiver is interfered by a harmonic wave of a VHF antenna.

  • Page 10: Wiring

    10 meters, use the optional cable assy. (10 m). Up to four extension cables can be connected serially. Connecting to FURUNO NavNet equipment Connect the antenna cable to the DATA1 port on NavNet equipment. Antenna Cable 10 m Cable assy.

  • Page 11

    Connecting to Multi Display RD-30 WAAS is not operative in this installation. Antenna Cable 10 m 12-24 VDC Connecting to Echo Sounder LS-6100 Antenna Cable 10 m AUX port IN/OUT port ECHO SOUNDER LS-6100 NMEA 12 VDC POWER REAR MULTI DISPLAY RD-30 12-24 IN/OUT...

  • Page 12

    *2: Supply from breaker on switchboard Note 1: When connecting FURUNO DGPS beacon receiver GR-80 to this unit, set it as follows: Byte Format, 8-6; First Bit, LSB; Parity Bit, None; Stop Bit, 1; Bit Rate, 8.

  • Page 13

    Output/Input data sentences Priority Input Data High XXGGA GPS position status (time of fix, latitude, longitude, receive status, satellite used) XXZDA UTC date (time in minutes and seconds, day, month, year, time) XXGLL Position (latitude, longitude) XXRMC Navigation data (UTC time and latitude, longitude, ground speed, true course, year,...

  • Page 14: Default Settings

    3. DEFAULT SETTINGS Setting Initial Latitude/Longitude Date, Time Antenna Height Almanac Data Ephemeris Data Local Zone Time PDOP Geometric Datum Mask Elevation Disable Satellite Smoothing Coefficient Dynamic Coefficient Data Output (Cycle) DGPS Setting Parameter GEO Satellite, Provider ID WAAS Availability Type 0 Message Default setting North=34°44.0000, East=135°21.0000...

  • Page 15: Troubleshooting, Battery

    If the message “No position data” appears on the display of NavNet equipment, there may be a problem with the GPS receiver. Turn off the power and then check the following points: 1) Check for objects around the antenna which may interfere with reception.

  • Page 16

    4. ENVIRONMENTAL CONDITIO N Ambient Temperature Relative Humidity Water proofing Vibration 5. COATING COLOR GP-320B 12 channels parallel, 12 satellites tracking 1 channel 1575.42 MHz C/A code, WAAS All in view, 8-state Kalman filter 10 m (95% of the time, HDOP 4)

  • Page 17

    PACKING LIST GP-320B(E) N A M E ユニット UNIT GPS受信機 GPS RECEIVER 図書 DOCUMENT 取扱説明書 OPERATOR'S MANUAL 型式/コード番号が2段の場合、下段より上段に代わる過渡期品であり、どちらかが入っています。 なお、品質は変わりません。 TWO TYPES AND CODES MAY BE LISTED FOR AN ITEM. THE LOWER PRODUCT MAY BE SHIPPED IN PLACE OF THE UPPER PRODUCT. QUALITY IS THE SAME.

  • Page 18

    Sep.20 '02...

  • Page 20

    Nishinomiya, 662-8580, JAPAN Telephone : +81-(0)798-65-2111 : +81-(0)798-65-4200 Printed in Japan All rights reserved. Pub. No. OME-44220-B2 (AKMU ) GP-320B The paper used in this manual is elemental chlorine free. ・FURUNO Authorized Distributor/Dealer A : APR B2 : JAN . 13, 2011...

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: