Adding/Deleting Channels - Magnavox MWR10D6 Owner's Manual

To select a channel
You can select a channel by directly entering channel using the Number buttons on the remote control.
Notes for using the Number buttons:
• When selecting cable channels which are higher than 99, enter channel numbers as a three-digit
number.(For example: 117, press [1], [1], [7])
• You must precede single-digit channel numbers with a zero (For example: 02, 03, 04 and so on).
• You can select the line input mode ("E1" or "E2"). To select "E1" by pressing [0], [0], [1]. To select "E2" by
pressing [0], [0], [2]. Details are on page 35.
Note
• If the auto channel presetting is cancelled during presetting, some channels not yet preset may not be
received.
• The selection will depend on how you receive the TV channels.
To cancel the auto channel presetting during scanning:
Press [RETURN] or [SETUP] to cancel.
Adding/deleting
channels
The channels you no longer
receive or seldom watch can
be deleted from the memory.
You also may add channels into
memory.
1
Press [SETUP].
2
Using [K / L], select "Channel".
Press [OK].
Channel menu will appear.
3
Using [K / L], select "Manual
Channel Preset". Press [OK].
Manual Channel Preset menu will
appear.
Manual Channel Preset
CH 2
Add
Delete
Getting started
Channel setting (cont'd)
4
Select the channel number to
add or delete.
Press [{] or [CHANNEL
move to a lower channel number.
Press [B] or [CHANNEL
move to a higher channel number.
Press the Number buttons to
select a channel number directly.
Manual Channel Preset
CH 7
Add
Delete
5
Using [K / L], select "Add" or
"Delete". Press [OK].
The channel number will be
added or deleted from the channel
memory. Then the next channel
number will appear so that you
can continue adding or deleting
channels.
6
Press [SETUP] to exit.
-
] to
4
+
] to
2
3
4
5
Note
• [CHANNEL
the memorized channel in this
unit.
• [{ / B] works on all of
channel numbers.
1
6
4
- +
/ ] works on
EN 19