Removing The Palm Rest; Replacing The Palm Rest - Dell Latitude E6410 Service Manual

Back to Removing and Replacing Parts
Palm Rest
Dell™ Latitude™ E6410/E6410 ATG Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Palm Rest

NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your
2. Remove the ATG Port Cover
3. Remove the battery.
4. Remove the SIM card.
5. Remove the SD card.
6. Remove the ExpressCard.
7. Remove the Smart card.
8. Remove the hinge covers.
9. Remove the access panel.
10. Remove the optical drive.
11. Remove the hard drive.
12. Remove the LED cover.
13. Remove the keyboard.
14. Remove the coin-cell battery.
15. Remove the memory.
16. Remove the WWAN card.
17. Remove the WLAN card.
18. Remove the Latitude ON™ Flash/CMG module.
19. Remove the coin-cell battery.
20. Remove the Fingerprint Reader.
21. Remove the Heat Sink and Processor
22. Remove the Display Assembly.
23. Remove the 8 screws (Number 1 is a captive screw) from the bottom of the computer.
NOTE: If the computer is installed with a standard palm rest, see the
which is a captive screw.
24. Remove the screws that secure the palm rest to the computer.
25. Disconnect the speaker cable (1), power button cable (2), touch pad cable(3), and RFID cable (4).
NOTE: RFID cable is available only if your computer is purchased with contactless smart card solution.
26. Lift the back edge of the palm rest and pull on the right side to release the right snaps. Once the right snaps release, pull the palm rest forward along
the front to release the front snaps and remove the palm rest.

Replacing the Palm Rest

To replace the palm rest, perform the above steps in reverse order.
Back to Removing and Replacing Parts
Computer.
(applicable on E6410 ATG computer only).
Fan.
fingerprint reader removal instructions from step 8 to loosen the 9th screw