Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 40

applynetwork(8)
EXAMPLES
18 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
Unless all of the host name, DNS domain name, IP address, net mask, and
■
routing settings have been made on the target interface, it results in errors.
Please execute the sethostname(8) and setnetwork(8) command to set all
items, then reexecute the applynetwork(8) command.
To set to multiple interfaces, all of the host name, DNS domain name, IP address,
■
and net mask settings need to be set on every interface. In these interfaces, if any
of these setting items omitted, it results in errors.
To specify a host name, use the sethostname(8) command. To specify an IP
■
address and net mask, use the setnetwork(8) command.
When the status is down in all network interfaces, it results in errors.
■
On the M8000/M9000 servers, when you set different netmask in the following
■
interfaces, it results in errors.
xscf#0-lan#0, xscf#1-lan#0, lan#0
■
xscf#0-lan#1, xscf#1-lan#1, lan#1
■
xscf#0-if, xscf#1-if
■
Reflects the information that has been set for the XSCF network.
EXAMPLE 1
On the M3000/M4000/M5000 servers:
applynetwork
XSCF>
The following network settings will be applied:
xscf#0 hostname
DNS domain name
nameserver
interface
status
IP address
netmask
route
interface
status
IP address
netmask
:hostname-0
:example.com
:10.23.4.3
:xscf#0-lan#0
:up
:10.24.144.214
:255.255.255.0
:-n 0.0.0.0 -m 0.0.0.0 -g 10.24.144.1
:xscf#0-lan#1
:down
:
: