Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 274

setsnmp(8)
252 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
When used alone, activates the SNMP agent with support for all
enable
MIB modules.
When used with the value ALL for the optional mib_name,
activates the SNMP agent with support for all MIB modules.
When used with a value other than ALL for the optional
mib_name, adds support for the targeted MIB module and, if
necessary, activates the SNMP agent. You can specify only one
value at a time for mib_name.
mib_name
Valid MIB modules are:
SP_MIB = XSCF extension MIB
FM_MIB = Fault Management MIB
ALL = All the MIB modules in this list.
Enables the SNMP agent to communicate using SNMPv1/v2c.
enablev1v2c
These versions provide insecure SNMP communication, which is
why the agent runs SNMPv3 by default. This agent is read-only.
The only community string asked for is read-only.
Disables the SNMP agent from sending the chosen type of trap to
remtraphost
the desired host.
-t type
v1 = The agent will send SNMPv1 traps
v2 = The agent will send SNMPv2 traps
inform = The agent will send inform notifications
traphost
remv3traphost Disables the SNMP agent from sending SNMPv3 traps to the
desired host.
traphost
-u username
Name of the MIB module to be enabled.
Type of trap. Valid trap types are:
Host name or IP address of the trap host.
Host name or IP address of the trap host.
Specifies a valid user name.