Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 196
Xscf control package (xcp) 109x
Hide thumbs
Also See for SPARC Enterprise M3000:
- Xscf reference manual (560 pages) ,
- Service manual (202 pages) ,
- Product notes (144 pages)
Table of Contents
Advertisement
setdomainmode(8)
174
SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2009
-m function=mode Sets the modes of operation and specifies its values. Use function
to set the modes of operation. One of the following can be
specified:
diag
secure
autoboot
cpumode
When diag is specified for function, any of the following can be
specified for mode:
Note – When the domain is in any status other than powered
off, it results in an error.
none
min
max
When secure is specified for function, one of the following can
be specified for mode. The setting will be reflected after domain
power on or restart.
on
off
When autoboot is specified for function, one of the following
can be specified for mode. The setting will be reflected after
domain power on or restart.
on
off
Specifies the OpenBoot PROM diagnostic
level.
Specifies whether to enable or disable the
host watchdog and suppress break signal
reception.
Specifies whether to enable or disable the
Auto boot function.
Sets the operational mode of CPU. When you
specified cpumode on the M3000 server, it
results in an error.
No diagnosis is performed.
Sets standard for the diagnostic level.
Sets maximum for the diagnostic level.
Enables the host watchdog and suppress
break signal reception.
Disables the host watchdog and suppress
break signal reception.
Enables the Auto boot function.
Disables the Auto boot function.
Advertisement
Table of Contents
