Sendbreak - Fujitsu SPARC Enterprise M3000 Xscf Reference Manual

Xscf control package (xcp) 109x
Hide thumbs Also See for SPARC Enterprise M3000:
Table of Contents

Advertisement

NAME
sendbreak - send a break signal to the specified domain
SYNOPSIS
sendbreak -d domain_id
sendbreak [ [-q] -{y|n}] -d domain_id
sendbreak -h
DESCRIPTION
The sendbreak(8) command sends a break signal to the specified domain.
When a break signal is sent from the domain console to the Solaris OS of the
domain, control is transferred from the Solaris OS to OpenBoot PROM and the
OpenBoot PROM prompt "ok" is displayed.
Note – sendbreak(8) command will not work when the secure mode is set to 'on'
while the mode switch on the operator panel is set to "Locked". Refer to the
setdomainmode(8) for more information.
You must have one of the following privileges to run this command:
Privileges
platadm
domainadm
Refer to setprivileges(8) for more information.
OPTIONS
The following options are supported:
-d domain_id
-h
-n
-q
-y
EXIT STATUS
The following exit values are returned:
0
>0
SEE ALSO
console(8), showconsolepath(8)
Can run this command for all domains.
Can run this command only for your managed domains.
Specifies only one ID of the domain to which to send the break
signal. domain_id can be 0–23 depending on the system
configuration.
Displays usage statement. When used with other options or
operands, an error occurs.
Automatically answers "n" (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Automatically answers "y" (yes) to all prompts.
Successful completion.
An error occurred.

sendbreak(8)

System Administration
141

Advertisement

Table of Contents
loading

Table of Contents