GE Profile PS920SFSS Dimensions And Installation Information

PS920SF
GE Profile Series 30" Slide-In Electric Convection Range with Warming Drawer
™
Dimensions and Installation Information (in inches)
Receptacle Locations: Locally approved flexible service cord or conduit must be used because
terminals are not accessible after range installation. See shaded area in drawing for location of
electrical outlet box. Recommended outlet locations allow range to be installed directly against rear
wall.
Note: This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop.
However, a 6" minimum spacing to surfaces less than 15" above the cooktop and adjacent
cabinet is recommended to reduce exposure to steam, grease splatter and heat.
Installation Information: Before installing, consult installation instructions for current
dimensional data and additional requirements.
KW Rating
240V 13.5
208V 10.1
Breaker Size
240V 40 Amps
†
208V 40 Amps
†
Note: Check local codes for required breaker size.
†
NOTE: Use a 4' power cord to prevent interference
with unit when installing.
NOTE C
* Depth including door handle is approximately 28-7/8".
*Depth including door handle is approximately 28-7/8".
For answers to your Monogram or GE
®
appliance questions, visit our website at
B
geappliances.com or call GE Answer Center
C
service, 800.626.2000.
Both
Sides
PHS920SF/PS920SF
29 ⁄ "
7
8
29 ⁄ "
7
8 31 ⁄ "
1
4
36"
37 ⁄ "
1
4
25 ⁄ "
7
8
*28 ⁄ "
7
8
⁄ "
48
1
4
*
* ADA qualified based
on Uniform Federal
®
Accessibility Standards
®
NOTE: Use a 4' power cord to prevent interference
with unit when installing.
NOTE C
A
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 5/13
MINIMUM DIMENSIONS BETWEEN COOKTOP, WALLS AND ABOVE THE COOKTOP:
A. Make sure the wall covering, countertop, ooring and cabinets around the range ca
B
C
Both
Sides
A
Listed by
Underwriters
Laboratories
220459