If no function is assigned to the expression pedal
The bank/value display will blink "
Quick Assign to assign a function (p. 31, "Assigning a
function to the expression pedal (Quick Assign)").
2. Use the EDIT knob of the assigned effect (whose on/off
switch LED is blinking), or the GAIN control to specify
the minimum value.
HINT: You can skip this step, if you do not change the mini‐
mum value.
3. Press the EXPRESSION switch.
The bank/value display will indicate "
4. Use the EDIT knob you used in step 2, or the GAIN con‐
trol to specify the maximum value.
HINT: You can skip this step, if you do not change the maxi‐
mum value.
NOTE: If you decide to cancel the setting, press the EXIT/
TUNE switch.
5. Press the EXPRESSION switch.
The bank/value display will indicate "
second.
The Quick Assign LED will go dark.
NOTE: The assignment of a function to the expression ped‐
al, the minimum value, and the maximum value
are specified independently for each program.
". In this case, use
Adjusting the minimum and maximum volume
".
" for about one
6. If desired, save these settings to the program.
For details on the procedure, refer to "Saving a program"
(p. 15).
NOTE: The settings you made will return to their original
values if you switch programs or turn off the power
before saving.
If volume is assigned to the expression pedal, you can adjust
the minimum and maximum values as follows.
1. Press the EXPRESSION switch.
The EXPRESSION PEDAL LED and Quick Assign LED
will blink, and the bank/value display will indicate "
2. Use the VOLUME control of the AMP section to specify
the minimum value, and then press the EXPRESSION
switch.
The minimum value will be specified, and the bank/value
display will indicate "
3. Use the VOLUME control to specify the maximum value,
and then press the EXPRESSION switch.
The bank/value display will indicate "
second.
".
" for about one
".
33