2. Use a cable to connect the ToneLab EX's OUTPUT/
PHONES jack to your guitar amp, mixer, or other device.
NOTE: Before connecting the ToneLab EX, lower the vol‐
ume level of your guitar amp or mixer.
The OUTPUT/PHONES is equipped with a stereo output
jack. Use a stereo (TRS) cable to enjoy listening to or re‐
cording with your ToneLab EX in stereo.
If your amplifier or mixer has only mono inputs, you can
purchase a cable that has a stereo plug on one end, and
two mono plugs (Left and Right) on the other.
Connecting a mono cable to the OUTPUT/PHONES jack
will only pick up the sound from Left channel.
3. Set the LEVEL knob and SPEAKER LEVEL knob on the
rear panel to "0" by turning the knob all the way to the left
(as seen from the rear panel).
4. Connect the plug end of the AC adapter
(included) to the DC12V jack on the rear
panel of the ToneLab EX, and the other
end into an AC outlet.
Secure the AC adapter cable around the
cable hook; this will reduce stress on the
plug end of the adapter, and prevent it
from disconnecting accidently.
5. Using a standard guitar cable, connect your guitar to the
INPUT jack of the ToneLab EX
6. Make sure that the volume of your amp or mixer is
turned down, and then set the ON/STANDBY switch on
the ToneLab EX to the "ON" position.
10
7. Raise the volume controls of your amp or mixer to their
normal levels, and use the LEVEL knob or SPEAKER
LEVEL knob on the rear panel to adjust the volume to a
suitable level.
NOTE: The ToneLab EX uses a vacuum tube, so it may take
a few seconds for the vacuum tube to warm up, and
for the ToneLab EX to produce sound.
Trying out the ToneLab EX
The ToneLab EX has a total of two hundred programs, con‐
sisting of rewritable user programs (Banks 1–25 x 4) and pre‐
set programs (Banks 26–50 x 4).
Performance modes
The ToneLab EX features two performance modes: Program
Select mode enables you to select and play programs; Stomp
Box mode enables you to turn on or off individual effects
assigned in the selected program.
Switching between modes
Press both the BANK UP and BANK DOWN pedals simulta‐
neously for one second.
Repeat this operation to toggle between Stomp Box mode and
Program Select mode.
If the Bank/Value display indicates a bank number, Program
Select mode is engaged. If the display indicates "
Box mode is engaged.
," Stomp