Gigabyte GA-970A-D3P User Manual page 58

B. Installing Windows XP
Before installing Windows XP, connect a USB floppy disk drive to your computer first because you need to install
the SATA RAID/AHCI driver from a floppy disk that contains the driver during the OS installation. Without the
driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver from
the motherboard driver disk to a floppy disk. Refer to the methods below.
Method A:
• For the AMD SB950, copy all files in the \BootDrv\Hxp folder to your floppy disk.
Method B:
Steps:
1: Use an alternative system and insert the motherboard driver disk.
2: From your optical drive folder, double click the Menu.exe file in the BootDrv folder. A Command Prompt
window will open similar to that in Figure 2.
3: 3: Insert the blank formatted disk (if you're using a USB floppy disk drive, make sure it is designated as drive
A). Select the controller driver by pressing the corresponding letter from the menu and press <Enter>. For
example, from the menu in Figure 2, for the AMD SB950, select 6) hseries AHCI/RAID for XP.
Your system will then automatically copy the driver files to the floppy disk. Press any key to exit when finished.
Configuring SATA Hard Drive(s)
Figure 2
- 58 -