Download Print this page

Panasonic FV-05VS3 User Manual

Fv05vs3 user guide

Advertisement

Quick Links

FV-05VS3 FV-08VS3 FV-10VS3
(Joist Mounting)
(Wall Mounting)
(Cleaning)
2-3
4
4
4
4
5
5-6
6
7
Back cover
Back cover
Back cover

Advertisement

loading

Summary of Contents for Panasonic FV-05VS3

  • Page 1 FV-05VS3 FV-08VS3 FV-10VS3 (Joist Mounting) (Wall Mounting) (Cleaning) Back cover Back cover Back cover...
  • Page 2: For Your Safety

    For Your Safety To reduce the risk of injury, loss of life, electric shock, fire, malfunction, and damage to equipment or property, always observe the following safety precautions. Explanation of symbol word panels The following symbol word panels are used to classify and describe the level of hazard, injury, and property damage caused when the denotation is disregarded and improper use is performed.
  • Page 3 USA only: This product has a fluorescent lamp that contains mercury. Disposal may be regulated in your community due to environmental considerations. For disposal or recycling information, please contact your local authorities or visit Panasonic website: http://www.panasonic.com/environmental or call 1-888-769-0149.
  • Page 4 Installation Grille instructions Warranty Long screw sheet (ST4.2X30) 7/8 (22.5) 3 3/8 (85) 3 3/4 (94) 10 1/4 (260)
  • Page 5 Joist Joist a clamp and seal it with approved duct tape or mastic. (If using 3 inch round duct, please purchase the 26 gauge steel Panasonic 4" Oval - 3" Round Reducer from our representative.)(Fig.3) Squeeze Neutral...
  • Page 6: Installation

    6. Finish ceiling work. Ceiling hole should be aligned with the inside edge of the flange. (Fig.4) After finishing the ceiling job, fill gap between flange and ceiling with caulk or other sealant to 7. Remove the tape from mounting springs prevent air leakage.
  • Page 7 WARNING CAUTION Fig.9 1. Remove grille. (Squeeze mounting springs and pull down carefully.)(Fig.9) 2.Wash and clean grille. (Use non-abrasive kitchen detergent, wipe dry with Fig.10 clean cloth.)(Fig.10) 3. Remove dust and dirt from fan body using a vacuum cleaner. (Fig.11) 4.
  • Page 8 Properly insulate the area around the fan to minimize building heat loss and gain. (Fig.13) Loose fill or batt insulation can be placed directly over the fan housing in the attic. Our fans and fan/light combination units do not create excessive heat that is a common problem with recessed light fixtures or some competitor’s fan/light...

This manual is also suitable for:

Fv-08vs3Fv-10vs3