Hardware Support; Power Connector - Intel DB85FL Specification

1.12.2

Hardware Support

CAUTION
Ensure that the power supply provides adequate +5 V standby current if LAN wake
capabilities and Instantly Available PC technology features are used. Failure to do so
can damage the power supply. The total amount of standby current required depends
on the wake devices supported and manufacturing options.
The board provides several power management hardware features, including:
•

Power connector

Fan headers
•
LAN wake capabilities
•
Instantly Available PC technology
•
Wake from USB
•
PCI Express WAKE# signal support
•
Wake from S5
•
• Power Supervisor
+5 V Standby Power Indicator LED
•
LAN wake capabilities and Instantly Available PC technology require power from the
+5 V standby line.
NOTE
The use of Wake from USB from an ACPI state requires an operating system that
provides full ACPI support.
1.12.2.1 Power Connector
ATX12V-compliant power supplies can turn off the system power through system
control. When an ACPI-enabled system receives the correct command, the power
supply removes all non-standby voltages.
When resuming from an AC power failure, the computer returns to the power state it
was in before power was interrupted (on or off). The computer's response can be set
using the Last Power State feature in the BIOS Setup program's Boot menu.
For information about
The location of the main power connector
The signal names of the main power connector
Product Description
Refer to
Figure 9, page 42
Table 23, page 47
35