Frymaster BK1814E Series Installation & Operation Manual page 25

4.5.1 Filter Operation (cont.)
11. Lower the elements into the frypot.
12. Replace the basket support rack, using care
not to splash hot oil.
13. Ensure the drain valve is fully closed. (If the
drain valve is not fully closed, the fryer will
not operate.) Turn the fryer ON and allow
the oil to reach setpoint.
14. Do not allow crumbs to accumulate in the
crumb tray. The crumb tray MUST be
emptied into a fireproof container at the end
of frying operations EACH DAY (see
DANGER statement below).
The crumb tray in fryers equipped with a filter system must be emptied into a fireproof
container at the end of frying operations each day. Some food particles can spontaneously
combust if left soaking in certain shortening material.
Do not bang fry baskets or other utensils on the fryer's joiner strip. The strip is present to
seal the joint between the fry vessels.
shortening will distort the strip, adversely affecting its fit. It is designed for a tight fit and
should only be removed for cleaning.
The filter pump is equipped with a manual reset switch in case the filter motor overheats or
an electrical fault occurs. If this switch trips, turn off power to the filter system and allow the
pump motor to cool 20 minutes before attempting to reset the switch (see photo below).
Replace the basket support rack,
using care not to splash hot oil.
Empty the filter pan crumb tray into a fire-
proof container at the end of frying operations
each day.
ACCUMULATE IN TRAY.
DANGER
WARNING
Banging fry baskets on the strip to dislodge
WARNING
Filter Pump Reset Switch
4-10
DO NOT ALLOW CRUMBS TO