Table of Contents
Advertisement
DRPD Pattern: Specifies a distinctive ring pattern for use with DRPD service. DRPD Patterns are
■
specified by your telephone company. The patterns provided with your multifunction printer are
shown below:
Note:
Ask your telephone company which pattern you need to select to use this service. For example,
Pattern 7 is the New Zealand FaxAbility distinctive ringing pattern: rings for 400 ms, stops for 800 ms,
rings for 400 ms and stops for 1400 ms. This pattern is repeated over and over again.This printer only
responds to Distinctive Alert cadence(s) DA4 in New Zealand.
Forward Settings: Specifies when the printer should forward all of the outgoing faxes to a specified
■
destination.
Trans. at Error: Outgoing faxes are forwarded only when an error occurs.
■
Trans. Always: Outgoing faxes are always forwarded.
■
Not Trans.: Outgoing faxes are not forwarded.
■
Fwd. Settings Num: Specifies the number that outgoing faxes are forwarded to.
■
Fwd. Set Print: Specifies if the outgoing faxes should be printed when they are forwarded. When set
■
to On, all of the forwarded faxes are printed.
Fwd. Error Print: To print the documents failed to transfer when Fwd. Set Print is set to Off.
■
Off: Does not print documents that fail to transfer when Fwd. Set Print is set to Off.
■
On: Prints documents that fail to transfer when Fwd. Set Print is set to Off.
■
Prefix Dial: Specifies whether or not to add the prefix number when you send a fax.
■
Prefix Dial Num: Specifies the prefix dial number, up to five digits. This number dials before any auto
■
dial number is started. It is useful for accessing the PBX exchange.
Discard Size: Specifies if the printer should discard any excess data at the bottom of the page.
■
On: Discards any excess data at the bottom of the page.
■
Off: Prints any excess data at the bottom of the page without discarding it.
■
Auto Reduction: Reduces the document to fit onto the paper.
■
ECM: Sets whether to enable or disable the Error Correction Mode (ECM). To use the ECM feature,
■
the remote machines must also support ECM.
On: Enables the ECM feature.
■
Off: Disables the ECM feature.
■
Extel Hook Thresh: Specifies the threshold value for the external telephone.
■
Modem Speed: Specify the communication (modem) speed for transmission/reception.
■
Patter
n 1
Pattern 2
Pattern 3
Pattern 4
Pattern 5
Pattern 6
Pattern 7
9-11
Description of Menu Items
Advertisement
Table of Contents
