Table of Contents
Advertisement
Note
• When [Fixed %] or [Full Size] is set at [Zoom Mode], the scaling factor is automatically set by the
combination of [Document Size] and [Output Size]. When the 2 Up mode is set, the scaling factor is
automatically set by halving the combination of [Document Size] and [Output Size].
• [**] is displayed when the currently loaded paper size is unknown.
Document Size
Sets the size and orientation of the document prepared by the client.
Candidate values are shown below.
[SEF] (default)
This is the same size as that specified at [Output Size].
[LEF]
[A4 SEF] [A4 LEF] [A3 SEF] [A3 LEF] [A5 SEF] [A5 LEF] [B4 SEF] [B4 LEF] [B5 SEF]
[B5 LEF]
[11×17-S] [11×17-L]
[8.5×14-S] [8.5×14-L]
[8.5×13-S] [8.5×13-L]
[8.5×11-S] [8.5×11-L]
[R15×12-L] (continuous roll paper 15 × 12, guaranteed number of printing digits 136 digits/
72 lines)
[R15×11-L] (continuous roll paper 15 × 11, guaranteed number of printing digits 136 digits/
66 lines)
[R10×12-S] (continuous roll paper 10 × 12, guaranteed number of printing digits 80 digits/
72 lines)
[R10×11-S] (continuous roll paper 10 × 11, guaranteed number of printing digits 80 digits/
66 lines)
Note
• When continuous roll paper is selected at [Document Size], [Page Position] cannot be set.
• When [Fixed %] or [Full Size] is set at [Zoom Mode], the scaling factor is automatically set by the
combination of [Document Size] and [Output Size]. When the 2 Up mode is set, the scaling factor is
automatically set by halving the combination of [Document Size] and [Output Size].
• The orientation set here is the orientation of the document. This does not influence the orientation of the
paper loaded in the trays.
Quantity
Sets the number of copies to print.
Set within the range 1 (default) to 250.
Important
• When the client has specified the number of copies to print, that value is reflected and that number of
copies is printed. After printing ends, the setting on the control panel also is rewritten with that value.
Note, however, that the setting on the control panel is not rewritten with the number of copies specified
from the NetWare and LPD ports after printing ends.
Note
• When changing the candidate values by the <
continuously by holding the button down. The default is displayed by pressing the <
buttons simultaneously.
> or <
> button, the display can be changed
2.2 ESC/P Mode Menu Settings
> and <
>
15
Advertisement
Table of Contents
