Intercom Operation; Communication; Calling - Standard Horizon INTREPID GX1260S Owner's Manual

A weather channel.
MEM Indicator
The channel is in the transceiver's scan memory.
H/L Indicator
"H" is high power. "L" is low power. Blank is a reception only channel.
SQL/VOL Indicator
"SQL" is squelch adjusting mode. "VOL" is volume adjusting mode.

8.3 INTERCOM OPERATION

8.3.1 Communication

1. Press the IC key in the radio mode. The mode is changed to the
INTERCOM mode. If the IC key is pressed again the mode will
revert to radio mode.
2. "IC" is displayed on both the transceiver and the RAM Mic when the
intercom operation is activated.
3. Press the PTT switch. The "TX" indicator is displayed.
A warning beep is emitted when the RAM Mic PTT switch is pressed
while the transceiver microphone's PTT switch is pressed.
4. Speak slowly and clearly into the microphone, hold the microphone
about 1/2 inch away from your mouth.
5. When finished, release the PTT switch.

8.3.2 Calling

1. Hold down the IC key in the intercom operation for 1 second or
more. A calling beep is emitted twice from the transceiver speaker.
page 32
Figure 6. Intercom operation
NOTE
Owner's Manual
EXTERNAL
SPEAKER
NOTE:
If the RAM Mic is connected to
the transceiver, the external
speaker volume is controlled
by the RAM Mic. If the RAM
Mic is not connected to the
MIC
16/9 WX SCAN A/B transceiver, the external
LAMP
IC H/L
CALL
speaker volume is controlled
SUBMERSIBLE
by the radio.
RAM Mic
GX1260S