Accessory Cable; Cable Pin Number And Signal - Standard Horizon INTREPID GX1260S Owner's Manual

2. Connect the red power wire to a 13.8 VDC
Connect the black power wire to a negative ground.
3. If an optional remote extension speaker is to be used, refer to
section 4.3 for connections.
4. It is advisable to have a Certified Marine Technician check the
power output and the standing wave ratio of the antenna after
installation.

4.3 ACCESSORY CABLE

Cable pin number and signal

1 2
3 4 5
6 7 8
When connecting the external speaker or GPS navigation receiver, strip off
about 1 inch (2 cm) of the specified wire's insulation.
Never short wires. This may lead to malfunctions.
To external speaker and GPS receiver
To GX1260S
GX1260S
Pin number
1 External speaker (+)
2 External speaker (–)
3
4
5
6
7
8
NOTE
White: External speaker (+)
Yellow: External speaker (–)
Blue:
Green: NMEA IN (–) of GPS navigation receiver
Owner's Manual
20% power source.
Signal
No Connection
NMEA IN (+)
No Connection
NMEA IN (–)
No Connection
No Connection
NMEA IN (+) of GPS navigation receiver
page 9