Operation; Fan Speeds; On/Off Time Set; Setting The Temperature - Haier HPR09XC7 User Manual

English

Operation

NOTE: Wait for 24 hours to turn on air conditioner if the unit has been tilted for any
reason. This is for the oils and the coolants to settle and level off.
1. After a normal shut down wait for 3 minutes before restarting the unit so as to complete the
compressor cycle.
2. Use an 115v /15 amp outlet for the air conditioner. Do not use any other electrical appliances on this
line or you may trip the fuse. Use a dedicated line for this air conditioner.
3. Do not place the air conditioner in direct sunlight or close to any heating appliances
(eg. baseboard heaters, stoves, etc).
4. Operate on a flat surface only.
5. Keep the unit free of any obstructions such as drapes, curtains, blinds, etc.
6. Keep unit at least 1 foot away from the wall.
7. Check and clean the filter once every week for highest efficiency.
NOTE: Do not use unit without filter.
8. If the unit is not being used for a long period of time, remove the plug from the water drain pipe and
drain out any condensed water.
When turning on the unit for the first time after plugging it into an electrical outlet, the unit will start in a
low fan cool mode. The temperature reading out on the LED will be the current room temperature. When
turning on the unit during regular usage, it will remember the last setting used. If you want to operate the
air conditioner as a dehumidifier, then adjust to dehumidify mode.

SETTING THE TEMPERATURE

To set the temperature, press the + or the - key to raise or lower the temperature. The temperature can be
raised or lowered in the cool or dry mode. The temperature cannot be adjusted in the fan mode.

FAN SPEEDS

There are 3 adjustable speeds in the cool and fan mode: Low, Medium & High. In the dry or
dehumidification mode the fan will only operate at low speed.

ON/OFF TIME SET

The air conditioner has a 1-24 hour on/off built-in timer. To delay the start time for 1-24 hours at 1 hour
intervals, simply press "Timer" key (or On/Off Timer Key) to adjust the start time. Note that the unit has
to be plugged in to an electrical outlet for the timer to operate.
To automatically shut-off the unit, press "Timer" key while the unit is running to adjust the shut-off time.
The auto shut-off switch operates in all 3 modes: Cool, Dry & Fan.
NOTE: The temperature can be set between 61˚F to 89˚F.
7