Checking The Operating State - Gigaset SX763 User Manual

Checking the operating state

Your Gigaset SX763 WLAN dsl is now ready for use. The LED displays on the front panel
of the Gigaset SX763 WLAN dsl provide information about the operating state:
The LEDs (from left to right) have the following functions:
LED State
On (green)
Power
Off
On
Flashing
ADSL
Off
On
Line Flashing
Off
On
Online
Off
On (green)
Flashing
(green)
USB
Flashing
quickly
Off
On
LAN1 –
Flashing
LAN4
Off
On
Flashing
WLAN
Off
On
VoIP
Flashing
Off
Status
The Gigaset SX763 WLAN dsl is connected to the mains.
The Gigaset SX763 WLAN dsl is disconnected from the
mains.
A DSL connection is established.
The DSL line is being synchronised. The synchronisation
phases are shown as slow flashing (registering) and fast
flashing (training).
If no DSL cable is connected, the LED will flash at uniform
intervals.
DSL is deactivated.
One of the connected phones' receivers has been lifted for a
call (fixed network telephony).
The phone is ringing and a fixed network call is being
received or someone is waiting on the line.
There is currently no fixed network connection.
Connection to the Internet has been established.
There is no Internet connection.
A device is connected to the Gigaset SX763 WLAN dsl via the
USB port.
The connected device is active.
The device connected on the USB port is using too much
power (see (page 131)).
There is no device connected.
A device is connected to the relevant LAN port.
The relevant LAN port is sending or receiving data (traffic).
There is no device connected.
The radio interface is active.
The Gigaset SX763 WLAN dsl is sending or receiving data on
the radio interface.
The radio interface has been deactivated or no radio signal
is being received.
At least one port is configured for VoIP and VoIP access is
registered with the provider.
A call is currently being made via the Internet.
There is currently no connection for Internet telephony.
First steps
29