Related Manuals for Vax Agility V-123
Summary of Contents for Vax Agility V-123
- Page 1 Vax V-123 User Guide.qxd 10/8/07 15:43 Page 1 Vax careline 0870 6061248 Carpet washer Vax model number: V-123 Please read carefully before using this cleaner. www.vax.co.uk Always fully extend the mains cable before use. Retain for future reference.
- Page 2 Vax V-123 User Guide.qxd 10/8/07 15:43 Page 2 www.vax.co.uk 1. Diagram V-123 Fig.1/1 1 Handle grip 9 Brush setting selector 17 Hose inlet 2 Solution trigger 10 Nozzle 18 Handle release pedal 3 Clean Surge button 11 Recovery tank 19 On/Off pedal...
-
Page 3: Safety Information
Do not use with a damaged cord or plug. If the supply cord and/or plug is damaged, they must be replaced PLEASE KEEP THESE INSTRUCTIONS by the manufacturer, a Vax Service Agent or similarly FOR FURTHER USE. qualified persons in order to avoid hazard. - Page 4 Vax V-123 User Guide.qxd 10/8/07 15:43 Page 4 www.vax.co.uk 3. Preparing the Cleaner Raising the Handle Your cleaner is fully assembled and ready to start cleaning. Raise upper handle (A) to upright position until it locks in place (Fig.3/1). Fig.3/3 Use cap to measure the correct amount of solution according to the instructions on the bottle (Fig.3/4).
- Page 5 Vax V-123 User Guide.qxd 10/8/07 15:43 Page 5 Vax Careline 0870 606 1248 Fig.3/6 CAUTION: Solutions contain Anionic and Fig.3/8 Nonionic Surfactants. Avoid contact with the Empty tank and replace cap, securing both latches (Fig. 3/9). eyes and skin. In case of contact with eyes, flush with cold water for 15 minutes.
- Page 6 Vax V-123 User Guide.qxd 10/8/07 15:43 Page 6 www.vax.co.uk Drain the hose NOTE: The handle must be in the upright position in order to get cleaning solution through the hose. When finished using the hose and tool, remove water from the hose.
-
Page 7: Cleaning Carpet
Use the ‘Clean Surge’ button when cleaning heavily soiled areas of carpet (traffic areas, spots, etc.) Fig.4/1 NOTE: Use only Vax brand solutions in your deep cleaner. Other brands may damage the deep cleaner. Plan your cleaning to avoid walking on wet carpet. Start at the end of the room farthest from the exit and work in small sections. -
Page 8: Cleaning Upholstery
Continue using dry strokes until you see only a little solution coming up through the nozzle (front of cleaner). Pretreat spots, stains and high traffic areas with Vax stain treatment spray. Spray spot or area, then proceed with the Do not make the carpet too wet! Use no more than two next cleaning steps. -
Page 9: Maintenance
Vax V-123 User Guide.qxd 10/8/07 15:43 Page 9 Vax Careline 0870 606 1248 6. Maintenance Cleaning the Nozzle Unplug deep cleaner from electrical source. Remove solution and recovery tanks to prevent possible leaks. Lift up on top of nozzle and slide off cleaner (Fig.6/1). - Page 10 Vax V-123 User Guide.qxd 10/8/07 15:43 Page 10 www.vax.co.uk Wipe debris off filter. Slide filter back into place. Storing the Cleaner Empty solution tank and rinse thoroughly. Place empty solution tank on deep cleaner. Turn deep cleaner ON. Squeeze trigger and push deep cleaner forward and back several times.
-
Page 11: Troubleshooting
An answerphone will be available out of these hours. Any Cause: Not properly plugged into electrical outlet. queries or concerns about using your Vax, call the Vax Solution: Plug unit in firmly. Careline. Calls are charged at the UK national rate. - Page 12 Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the V-123 Agility is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.