Device Code - Blaupunkt TravelPilot E1/E2 Operating Instructions Manual

Device code

If you switch on a code-enabled device after it was disconnected from the vehi-
cle' s power supply, you will have to enter the device code. You can also disable
this code request feature.
Activating / deactivating the code request feature
1 Press the MENU button ?.
The setup menu appears in the display.
2 Mark and confirm the CODE menu item.
3 Mark and confirm the ON or OFF menu item.
The menu for entering the numerical code appears.
4 Enter the code as described in the section entitled " S witching on a coded
device after disconnection from the battery power supply" .
Once you have finished entering the whole numerical code and it is shown in the
display,
5 press and hold down the OK button ; for longer than 2 seconds.
A message appears informing you that the code request feature has been
activated or deactivated.
INTRODUCTION NAVIGATION RADIO CD / MP3
SE==INGS
CODE
TMC
CODE
ON
OFF
TMC
CODE
O O O O
TMC
CD CHANGER SETUP
NAV
NAV
NAV
89
APPENDIX