Advertisement
The RF-303 transmitters are capable of controlling separately installed RF-300,
RF-500, or RF-700 series alarm systems in two vehicles.
To code the RF-303 transmitters for two vehicles, follow the diagrams as shown
below. Before multiple vehicle programming can be achieved, it will be
necessary to enter the programming mode for each vehicle's alarm system.
NOTE: Program each vehicle separately. Do not enter the program modes on
both vehicles at the same time.
1. TWO VEHICLE OPERATION
VEHICLE #1
Enter the programming mode on vehicle #1 and push the ON/OFF button on the
transmitter for vehicle #1. The vehicle horn, or siren will respond with a
confirming chirp. Within five (5) seconds, push the AUX button on one of the
transmitters from vehicle #2. The vehicle horn, or siren will respond with a
confirming chirp. Both transmitters are now programmed to vehicle #1.
VEHICLE #2
Enter the programming mode on vehicle #2 and push the AUX button on the first
transmitter used for vehicle #1. The vehicle horn, or siren will respond with a
confirming chirp. Within five (5) seconds, push the ON/OFF button on the
second transmitter that had been previously programmed on vehicle #1. The
vehicle horn, or siren will respond with a confirming chirp. Both transmitters are
now programmed to
vehicle #2.
NOTE: In the boxes below, the first transmitter is assumed to be the primary
transmitter of vehicle #1, and the second transmitter is assumed to be the primary
transmitter of vehicle #2.
TRANSMITTER #1
TRANSMITTER #2
VEHICLE #1
VEHICLE #2
ON/OFF Button
AUX Button
AUX Button
ON/OFF Button
11
Advertisement
