Table of Contents
Advertisement
A：
Single file save. Manually save a file to C:\Video
All files saved will be recorded in a folder called C:\video. You can move these files later to
any location. Still images recorded with be in JPG format and can be viewed by any picture
viewer. All video images will be stored in AVI format and can be viewed in Windows media
player. An AVI driver may be necessary to view these film clips. This codec can be
downloaded from Microsoft.
B：
Multi files save. This will record all of the files saved during a session on Manual
record. The files will be displayed within the program and then saved to C:\video
Shooting / Recording mode
Preview：
C :
Auto recording. When this button is depressed the unit will automatically record for
approx 12 seconds once motion is detected from the passive infrared sensors in the sensor
light. These files will also be stored in C:\Video. The files vary in size depending on the
settings and the amount of complexity in the image. Caution should be used in choosing this
setting. If your sensor light is in a location where it will not often be triggered it will not
record many files. If the sensor light is in a high traffic area it could almost always be
recording. This can fill a small hard drive quickly. This setting will depend on your own
personal needs and the size of the hard drive. The average clip size is approximately 2.5
Mb. of disk space. These clips can be deleted when necessary. The clips will be time and
date stamped and they can be identified by the date of the clip. The time and date stamp is
based on the computer time within your system. Please insure the computer is set to the
correct date and time.
D：
Manual recording Photo- Capture Photo, JPG Image
E：
Manual recording Clip – Record video, AVI Movie
Setup： Channel Column
F： The user can select Channels 1 to4 for Single viewing or quad view if more than one
camera is attached to the system. Sensor lights sold separately. In quad mode the system
will display 1 to 4 cameras.
Alarm
G / H：
Alarm ON / OFF. When the alarm feature is enabled, a tone will played
through the computers speakers when the sensor light has been activated. Use this if an
audible warning is desired. The volume of this warning depends on the computers volume.
I：
RX and TX signal strength. This is a gauge of the signal strength or the camera
being viewed. It will not operate in Quad mode.
21
Advertisement
Table of Contents
