Table of Contents
Advertisement
In the device setup screen you will chose the camera you wish to program. Once this is clicked, you
will have 10 seconds to synchronize the camera. You should communicate with the person by the
camera light to get ready. When the camera Icon is clicked, the person at the light will depress and
hold in the DIP switch programming button on the top of the light until it is registered with the
program. This should take about 5 seconds. Once programmed the screen should show a picture
and the signal strength bars will be displayed. The range of the system is approx. 200 Ft.
Camera synchronization screen
Camera 1 set up completed.
19
Advertisement
Table of Contents
