ATN PS-40 Operator's Manual page 21

Night vision front sights
Hide thumbs Also See for PS-40:
Table of Contents

Advertisement

CAUTION
The PS-40 can not be attached to the riflescope/sporting scope
that have a focusing ring on the objective lens housing.
The scope mounting systems and inserts differ in attaching diam-
eters and are supplied on special order, taking into account the pa-
rameters of the scope. To choose the system # and insert refer to
the Table 2-1. For example, the scope mounting system #1 and 47
mm insert are necessary to mount the PS-40 on leupold 3.5-10x40
riflescope.
NOTE
Optical axes of the PS-40 and the riflescope should be matched.
Difference of the axes position more than 3 mm is not recom-
mended.
FIXING NUT
DAySCoPe oBJeCTIve leNS
FIGURE 2-5. PS-40 INSTALLED ON DAYSCOPE OBjECTIVE LENS
Install the PS-40 on dayscope objective lens as follows:
1. loosen and remove two mounting screws M4x8 the Quick re-
lease Mount, remove the mount and put it into the storage case.
2. Take off the output lens cap and put it into the storage case.
3. Insert the output lens into the scope mounting system and place
the rail of the mounting system where the Quick release Mount
was above the battery compartment of the sight.
M4X8 SCreW
rAIl For Ir 450
SCoPe MoUNTING SySTeM
INSerT
2-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ps40 mgc

Table of Contents