Before Reading these Instructions
E
N
G
L
I
S
You can operate this unit by pressing buttons on the main unit and the remote control unit.
H
1
∫ These instructions describe buttons that are concerned with operations as follows.
Example: Press [P·SET "] or [P·SET #]/["] or [#].
[buttons on the main unit]/[remote control unit]
∫ Some operations can be activated by pressing buttons only on main unit or remote control unit.
Those cases are described in the instructions.
Example: Press [OPEN] on the main unit.
Remote Control Unit Preparation
Battery Installation
1
Remove the battery holder.
Pull the battery holder by the position B while pushing
position A in the direction indicated by the arrow.
2
Install the battery on the battery holder.
Set a new battery properly with its "i" side facing up
as shown in the figure.
3
Insert the battery holder.
Push the battery holder back into its original position.
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
≥ Battery type: Panasonic lithium battery (CR2025) (included)
≥ Battery life:
Approximately 6 months with normal use (at room temperature)
Caution:
≥ Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
≥ Do not disassemble or short the battery. Do not throw a battery into a fire.
≥ Keep batteries away from children to avoid the risk of accidents.
≥ Be careful to observe proper local disposal rules when you dispose of batteries.
Point the remote control unit at the main unit's sensor.
10
CQ-DF602W
Lithium battery
(included)
Back side
Position B
Battery holder
Position A
General
Power
1
Turn the key in the ignition until the accessory in-
dicator lights.
ON: Press [SRC] (PWR)/[SOURCE] (POWER).
OFF:Press and hold [SRC] (PWR)/[SOURCE]
(POWER) again for more than 1 second.
≥ After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is acti-
vated.
(When security function is set to on
page 28)
DISP
SRC
CD RECEIVER WITH FULL DOT MATRIX DISPLAY
Remote control signal sensor
Source
2
Press [SRC] (SOURCE)/[SOURCE] to change the source.
Radio
CD player
(When a CD is in the player.)
CD changer control
(When a CD changer is con-
nected and magazine is in the
changer.) (
AUX-IN setting
A C C
O N
Note:
≥ When the power is switched on for the
first time, a demonstration message ap-
pears on the display.
To cancel this display, press [DISP] (dis-
play).
CQ-DF602W
OPEN
50W
4
P . SET
X
MOSFET
W
; / 1
N
5
TUNE
BAND
TRACK
O
6
SET/APM
X
DISC
[SOURCE]
(POWER)
page 20)
[DISP]
(Display)
CQ-DF602W
E
N
G
L
I
S
H
2
11