Vivotek FE8172V User Manual page 205

addv6
delv4
delv6
ip <IP address>
index <value>
return <return page>
8.16 UART HTTP Tunnel Channel
Note: This request requires Operator privileges.
Method: GET and POST
Syntax:
http://<servername>/cgi-bin/operator/uartchannel.cgi?[channel=<value>]
-------------------------------------------------------------------------
GET /cgi-bin/operator/uartchannel.cgi?[channel=<value>]
x-sessioncookie: string[22]
accept: application/x-vvtk-tunnelled
pragma: no-cache
cache-control: no-cache
-------------------------------------------------------------------------
POST /cgi-bin/operator/uartchannel.cgi
x-sessioncookie: string[22]
content-type: application/x-vvtk-tunnelled
pragma : no-cache
cache-control : no-cache
content-length: 32767
expires: Sun, 9 Jam 1972 00:00:00 GMT
User must use GET and POST to establish two channels for downstream and upstream. The x-sessioncookie
in GET and POST should be the same to be recognized as a pair for one session. The contents of upstream
should be base64 encoded to be able to pass through a proxy server.
Add IPv6 address into access list.
Delete IPv4 address from access list.
Delete IPv6 address from access list.
Single address: <IP address>
Network address: <IP address / network mask>
Range address:<start IP address - end IP address>
The start position to add or to delete.
Redirect to the page <return page> after the parameter is
assigned. The <return page> can be a full URL path or relative
path according to the current path. If you omit this parameter, it
will redirect to an empty page.
(capability.nuart > 0)
VIVOTEK
User's Manual - 205