Talon Tools FH2700 User Manual

Petrol high pressure cleaner

Advertisement

USER MANUAL
Petrol High Pressure Cleaner
Model. FH2700
WARNING • PLEASE READ
For your own safety please read this manual before attempting to operate your new unit. Failure to follow instructions
can result in serious personal injury. Spend a few moments to familiarize yourself with your petrol high pressure
cleaner before each use.
MODEL NO. FH2700/FH2701
7096-270003
Model. FH2701
WARRANTY INFORMATION
PETROL HIGH PRESSURE CLEANER WARRANTY
The benefits conferred by this warranty are in addition to all other conditions and warranties in respect of this
product which the consumer may have taken under the Trade Practices Act 1974 or by any legislation of a
State or Territory of Australia. This product is warranted for home use by Talon Tools Australia (ABN 12 099
520 939)(the "Company") to be free from defects in material and workmanship for a period of 24 months from
the date of original purchase. The Company during the period of the warranty, will at its option, and subject
to the conditions stated herein, repair or replace without charge this product or any component part, which
upon examination by an Authorised Service Agent or by the Company is found to be defective.
Wa r r a n t y c o n d i t i o n s
This warranty will not apply:
(i) where this product has been subjected to misuse, abuse, accident or want of care;
(ii) where this product has been used for a purpose for which it was not designed or is not suited;
(iii) where the service of this product has been undertaken by a person not authorised by the Company
to carry out such work or where parts that have not been approved by the Company have been used;
(iv) where this product has been used for industrial or commercial purposes.
Should service become necessary during the warranty period, the purchaser should contact an Authorised
Service Agent or the Company. In order to obtain warranty service, the purchaser must present the store
receipt showing the name of the retailer and the date of purchase together with a completed Warranty
Card. The period of the warranty begins from the original date of purchase, notwithstanding any subse-
quent repair or parts replacement. No additional warranty or guarantee other than set out in this document,
whether written or verbal, is authorised to be made on the Company's behalf. The purchaser shall be
responsible for delivery or causing the product to be delivered to the Company or the Authorised Service
Agent and the purchaser shall be responsible for all charges in connection with re-delivery of the product
and/or the delivery of parts. Damage in transit is not covered by this warranty and purchasers should
remove from the product any liquids (if applicable) before sending and pack the product securely to pre-
vent damage.
Wa r r a n t y e x c l u s i o n s
Normal wear parts or components are subject to separate terms as follows: Normal wear parts, compo-
nents or service required when performing normal and regular maintenance of this product are not covered
by warranty unless it is found to be defective by an Authorised Service Agent or by the Company. Normal
wear parts include, but are not limited to:
Nozzles
Hose
Returns based on the above listed normal wear parts will not be accepted under this warranty as they
are considered consumable items and are at the expense of the purchaser.
AU
Failure caused by mineral or other deposits in
the Pump, Hose, Spraygun or Nozzles
1

Advertisement

Table of Contents
loading

Summary of Contents for Talon Tools FH2700

  • Page 1 Trade Practices Act 1974 or by any legislation of a State or Territory of Australia. This product is warranted for home use by Talon Tools Australia (ABN 12 099 520 939)(the “Company”) to be free from defects in material and workmanship for a period of 24 months from USER MANUAL the date of original purchase.
  • Page 2: Table Of Contents

    High Pressure Cleaner. If assistance is required, please WARRANTY........................1 contact Talon Tools Australia or any Talon Tools Authorised Servicing Dealer. To emphasise special information the DANGER, WARNING and CAUTION icons are used, please INTRODUCTION.......................
  • Page 3: General Safety Rules

    GENERAL SAFETY RULES GENERAL SAFETY RULES PLEASE READ AND SAVE THESE DANGER - RISK OF ELECTRIC SHOCK INSTRUCTIONS Safety Information • Unplug any electrically operated product before attempting to clean it. Direct spray Talon High Pressure Cleaners are designed to give safe and dependable service if operated according to away from electric outlets and switches.
  • Page 4: Technical Specifications

    TECHNICAL SPECIFICATIONS TECHNICAL INFORMATION DANGER - RISK OF UNSAFE OPERATION SPECIFICATION FH2700/FH2701 1. Do not use chlorine bleach or any other corrosive compound. ENGINE TYPE Air cooled, 4-cycle, Chrome Cylinder 2. Become familiar with the operation and controls of the pressure washer.
  • Page 5: General Identification

    • Attach nozzle extension to spray gun. • Select/attach quick connect nozzle to nozzle extension. 3-2. ATTACH HANDLE AND ACCESSORY TRAY-FH2700 NOTE: All assembly operations given in this section will be described from the perspective of assembling the pressure washer from the rear.
  • Page 6 Fig 3-3B Fig 3-4E Fig 3-4D 3-4. CONNECT HOSE AND WATER SUPPLY TO PUMP-FH2700 IMPORTANT You must assemble the nozzle extension and attach all hoses before you start the engine. Starting engine without all hoses connected and water supplied will damage the pump.
  • Page 7 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 3-5. CONNECT HOSE AND WATER SUPPLY TO PUMP-FH2701 Connect high pressure hose (B) to pump outlet. (A) (Fig. 3-5A). Connect the pump high pressure hose (C) with the winding wheel. (D) (Fig. 3-5B). Attach the other female end of the hose to the base of the spray gun (Fig. 3-5C). Run water through the garden hose for 30 seconds to clean out any debris.
  • Page 8: Starting The Engine

    (the engine switch will remain in the ON position). If the tighten the fuel tank cap firmly. Low Oil Shutdown system shuts down the engine, add engine oil. FUEL TANK CAPACITY: FH2700/FH2701 3.6 L...
  • Page 9: Warning

    PRE-OPERATION OPERATION 6. OPERATION WARNING 6.1 STARTING Prior to starting, refer to your engine manual for proper starting procedure. 1. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating of 91 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to Engine Owners •...
  • Page 10: Operation

    OPERATION OPERATION 6.3 MAINTENANCE SCHEDULE CAUTION DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump. THERMAL RELIEF  VALVE When the temperature inside the pump rises too high the valve will open and release a gush of water in an effort to lower the temperature inside the pump. The valve will then close (Fig. 6-6B). White Yellow NOTE Green Black (1) Service more frequently when used in dusty areas. (2) These items should be serviced by an authorized Talon dealer. 6.4 BASIC ELEMENTS OF A PRESSURE WASHER • High Pressure Pump: Increases the pressure of the water supply. Fig 6-6A Fig 6-6B • Engine: Drives the high pressure pump. • High Pressure Hose: Carries the pressurised water from the pump to the gun and spray wand. • Spray Gun: Connects with spray wand to control water flow rate, direction, and pressure. 6.7 OIL CHANGE • Quick Connect Spray Wand: Allows the user to quickly change high-pressure nozzles. See How To Drain the oil while engine is still warm to assure rapid and complete draining. Use Spray Lance instructions in this section. 1. Remove the drain plug, then drain the oil. • Chemical Hose (not shown): Feeds cleaning agents into the pump to mix with the water. See How To 2. Refill with the recommended oil to the specified level. Apply Chemicals/Cleaning Solvents instructions in this section. 3. Reinstall the drain plug and tighten securely. OIL CAPACITY: 0.6 Litres 6.5 PRESSURE WASHER TERMINOLOGY • PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure etc.
  • Page 11 OPERATION OPERATION/SPRAY LANCE 6.9 STORAGE 1. Drain the fuel a. With the fuel valve in the ON position, remove the carburetor drain screw (B) (side of carburettor bowl), and drain all the petrol from the fuel tank into a suitable container. (Fig. 6-8D) b.
  • Page 12: Spray Lance

    SPRAY LANCE SPRAY LANCE/CHEMICALS 7.3 NOZZLE CLEANING CAUTION If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. The high pressure spray from your pressure washer is capable of causing damage to surfaces such Clean the nozzle immediately using the nozzle kit supplied and the as wood, glass, automobile paint, auto striping and trim, and delicate objects such as flowers and following instructions:...
  • Page 13: Troubleshooting

    TROUBLESHOOTING 9. TROUBLESHOOTING THE PRESSURE WASHER PROBABLE CAUSE CORRECTIVE ACTION PROBLEM Pump has following problems: failure 1. Low pressure nozzle installed. 1. Replace nozzle with high pressure to produce pressure, erratic pressure, 2. Water inlet is blocked. nozzle. chattering, loss of pressure, low 3.

This manual is also suitable for:

Fh2701

Table of Contents