Miele S 560 series Operating Instructions Manual
Miele S 560 series Operating Instructions Manual

Miele S 560 series Operating Instructions Manual

Hide thumbs Also See for S 560 series:

Advertisement

Operating instructions

Vacuum cleaners
S 560 / S 570
S 700 / S 800 series
G
These operating instructions apply to standard
models S 560 - S 578, S 711 - S 749
and S 812 - S 849 as well as to other models
which are distinguished by
names rather than numbers.
M.-Nr. 05 783 452

Advertisement

Table of Contents
loading

Summary of Contents for Miele S 560 series

  • Page 1: Operating Instructions

    Operating instructions Vacuum cleaners S 560 / S 570 S 700 / S 800 series These operating instructions apply to standard models S 560 - S 578, S 711 - S 749 and S 812 - S 849 as well as to other models which are distinguished by names rather than numbers.
  • Page 2: Table Of Contents

    Floorhead ............14 Crevice nozzle .
  • Page 3 The transport and protective packing Old appliances may contain materials material has been selected from which can be reclaimed or recycled. materials which are environmentally Please contact your dealer, your local friendly for disposal and can normally waste collection centre or scrap be recycled.
  • Page 4 Some models are supplied with a Miele Electrobrush or Turbobrush as standard (not illustrated). These brushes are supplied with their own operating instructions.
  • Page 5: Floorhead

    Release button for accessories compartment x Hose connector y Suction hose The illustration shows the maximum number of features available on these Miele vacuum cleaners. Those features marked depend on the model and may vary or not be available...
  • Page 6 This appliance meets statutory A damaged vacuum cleaner can safety requirements. Inappropriate be dangerous. Check the vacuum use can however lead to personal cleaner and accessories for any signs injury and damage to property. of damage. Do not use a damaged Read the operating instructions appliance.
  • Page 7 Do not vacuum up liquids or damp Do not pull or carry the appliance dirt. This will cause major faults by the cable. When disconnecting and could seriously impair the from the mains socket pull by the plug functioning and electrical safety of the and not by the cable.
  • Page 8 The socket on the vacuum cleaner person in accordance with national and (depending on model) must only local safety regulations. Repairs and be used for the Miele Electrobrush other work by unqualified persons specified for use with this appliance. could be dangerous.
  • Page 9 ^ Insert the hose connector into the suction socket until it clicks into position. ^ Press the release buttons at the side of the hose connector and lift the hose from the socket. ^ To fit the handpiece of the suction hose into the suction tube, line up the guides on both parts and push in until they audibly lock together.
  • Page 10 (depending on model) Both sections of the suction tube have locating arrows marked on them. When connecting the two sections, ensure that the two arrows point towards each other. (depending on model) One part of the telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning.
  • Page 11 For hard flooring, such as stone and floors which are susceptible to scratching, e.g. parquet, we recommend using one of the special Miele floor brushes (see "Optional accessories"). It is also important to observe the flooring manufacturer's cleaning and care instructions.
  • Page 12: Crevice Nozzle

    Other tools, in addition to the floorhead(s), are supplied with the vacuum cleaner to help deal with various types of cleaning. a Crevice nozzle b Crevice nozzle extension (depending on model) c Dusting brush d Upholstery nozzle e Filter grille The filter grille e is supplied separately in the box only with those models which are fitted with an "ACTIVE air clean"...
  • Page 13 ^ Press the release button and the lid will open. ^ Take out the accessory you require. ^ Press down firmly on the lid to close The extension for the crevice nozzle is located in the compartment underneath the crevice nozzle.
  • Page 14 The different tools can either be fitted to the hand-piece or, as required, to the suction tube. Also for cleaning stairs. For cleaning in folds, crevices or corners. (depending on model) This accessory can be used to extend the length of the crevice nozzle. Further length is provided by pulling out the inner section.
  • Page 15 For cleaning skirting boards, ornate or carved articles, etc. The head of the dusting brush can be swivelled to attain the best cleaning position. For cleaning upholstery, mattresses, cushions, curtains, covers etc.
  • Page 16: Auto-Reverse

    ^ Hold the plug and unwind cable to the required length: – S 560 - S 578: max. approx. 6.5 m – S 711 - S 749: max. approx. 6.5 m – S 812 - S 849: max. approx. 8.5 m When vacuuming for longer than 30 minutes, pull the cable out to at least...
  • Page 17 ^ Press the On-Off switch. ^ When vacuuming pull the cleaner behind you on its wheels. You can stand it upright for vacuuming stairs and curtains etc. When vacuuming especially fine dust, e.g. sawdust, sand, plaster, flour, talcum powder etc., electrostatic charges build up naturally.
  • Page 18 The suction power can be regulated to suit the type of flooring. The higher the wattage the more powerful the suction. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead. Setting the suction power selector according to the degree of soiling and type of flooring being cleaned will save energy.
  • Page 19 ^ Turn the rotary selector manually to the suction power setting you require. ^ Move the slide selector manually to the suction power setting you require.
  • Page 20 Press the controls to select the suction power you require. ^ Press the control to select a higher setting. ^ Press the control to select a lower setting. When switched on the vacuum cleaner operates at the power setting last used. A single short press on the control moves the suction power up or down one setting at a time.
  • Page 21: Opening The Air Inlet Valve

    If the Automatic setting is chosen the vacuum cleaner automatically adjusts the suction power to suit the surface being cleaned. This ensures the correct power setting for the type of floor or carpet being cleaned. ^ Keep pressing the control until the Automatic setting is activated.
  • Page 22: Blowing Out

    (depending on model) The adapter is used to attach the suction hose connector to the blower connection socket so that the vacuum cleaner can be used to blow out air, e.g. for dusting off multi-layered radiators and blowing dust out of inaccessible corners so that it can be vacuumed up.
  • Page 23 A Park system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Fit the lower clip on the floorhead into the slot on the back of the vacuum cleaner from above (see illustration). (depending on model) Parking the floorhead in this way whilst vacuuming automatically switches off the cleaner.
  • Page 24 You can replace the exhaust filter supplied with the vacuum cleaner with one of the other Miele exhaust filters if you wish (see "Replacing one type of filter with another").
  • Page 25 Change the dustbag when the colour marker in the dustbag change indicator fills the display. Dustbags are designed for single use only. Do not attempt to re-use them as suction would be reduced. ^ Attach the standard floorhead to the suction tube.
  • Page 26 ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. ^ To remove the dustbag hold the bag by the collar and pull it out of its holder. The dustbag has a closing flap which closes automatically when the dustbag is removed to prevent any dust escaping.
  • Page 27 ACTIVE HEPA filter every time you start a new packet of dustbags. A SUPER air clean filter is supplied with every packet of Miele dustbags. approx. once a year. It should be replaced sooner if it is obviously soiled or no longer effective.
  • Page 28: Exhaust Filter Change Indicator

    The indicator light will go out when it is pressed. You can replace the exhaust filter supplied with the vacuum cleaner with one of the other Miele exhaust filters if you wish (see "Replacing one type of filter with another").
  • Page 29 ^ Open the dust compartment lid. ^ Release the filter grille and raise it upwards. Grasp the used SUPER air clean filter by the clean, unsoiled section (see arrow) and take it out. ^ Replace it with a new SUPER air clean filter.
  • Page 30 ^ Open the dust compartment lid. ^ Release the catch and remove the filter. ^ To insert the new filter, fit it so that it engages at the back and then close the catch. ^ Close the dust compartment lid firmly.
  • Page 31 Depending on model your vacuum cleaner will be fitted as standard with one of the following exhaust filters: SUPER air clean, ACTIVE air clean or ACTIVE HEPA 1. If you wish to replace the SUPER air clean filter with an ACTIVE air clean filter or an ACTIVE HEPA filter , it is essential that you...
  • Page 32 A dust compartment filter is supplied with every packet of Miele dustbags. ^ Open the dust compartment lid. ^ Unclip the filter frame, remove the old filter and replace with a new one.
  • Page 33 (bayonet connection) and pull out the pin. b Take out the roller. Remove all threads and hair etc, then replace the individual parts in the correct order. Spare parts are available from your Miele dealer or from the Miele Spare Parts Department.
  • Page 34 A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, Part Number 98013530, which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals.
  • Page 35 A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. Some models also have a warning light , which comes on to indicate that it has overheated. Overheating can occur if, for instance, large articles block the suction tube or the dustbag is full or contains particles of fine dust.
  • Page 36 In the event of a fault that you cannot easily remedy, please contact – your Miele Dealer – the nearest Miele Service Department. (See address on back page). Please note that telephone calls may be monitored and recorded to improve our service.
  • Page 37 (depending on model) Models designed to take an Electrobrush have a release button on the cover cap to the connection socket. If there is no release button on this cover cap an Electrobrush cannot be fitted. The Electrobrush is particularly suitable for intensive vacuuming of carpets which are subject to hard wear.
  • Page 38 (supplied as standard with some models) This brush is designed for use on hard flooring such as tiled or stone floors. (supplied as standard with some models) This brush has natural bristles and is designed for use on parquet floors and other surfaces which are susceptible to scratching such as laminate flooring.
  • Page 39 For dusting books, shelves, etc. This brush is suitable for particularly delicate objects. (can only be used if attached to the crevice nozzle) For cleaning radiators, narrow shelves and crevices.
  • Page 40 (supplied as standard with some models) For cleaning upholstery, mattresses, cushions, curtains, covers etc. For cleaning in folds, crevices or corners. This set is specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, intricately carved furniture and ornaments, models etc).
  • Page 41 The CarClean Set Plus has been designed as an accessory for Miele cylinder vacuum cleaners for valeting the interior of cars. It consists of: – Hand-held Turbobrush – Micro-hose with combination nozzle (crevice nozzle and dusting brush) – Crevice nozzle (300 mm)
  • Page 42 (supplied as standard with some models) The ACTIVE air clean filter is a special active charcoal filter which absorbs odours from the dust collected in the dustbag. It helps, therefore, to prevent a build-up of odours occuring. Do not use aroma capsules in your cleaner if you use this filter.
  • Page 43 The voltage, rated load and fuse rating showroom or Miele service agent. are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the The wires in the mains lead of this household mains supply.
  • Page 44 Alteration rights reserved / (560/570/700/800) - 3003 M.-Nr. 05 783 452 / 00 This paper consists of cellulose which has been bleached without the use of chlorine.

This manual is also suitable for:

S 570 series

Table of Contents