Controls And Input Connections; Switching On; Using The Remote Control; Using The Controls And Connections - Toshiba 32AV623D Owner's Manual

CONNECTING YOUR TV

Controls and input connections

A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
Illustration represents 32RV635D.
POWER switch
Input 3 (side)
will take priority over
EXT 3 (back) if both
connections are used
at the same time.

Switching on

If the RED LED is unlit, check that the mains plug is connected
to the power supply and press the
left side of the television to switch the television on. If the
picture does not appear, press
take a few moments. The GREEN LED will be lit.
To put the television into Standby, press
control. To view the television, press
take a few seconds to appear.

Using the remote control

Press MENU on the remote control to see the menus.
The menu appears as a list of five topics. As each symbol is
C c
selected by pressing or
remote control, its respective options will appear below.
NOTE: The same menu is displayed in DTV (Digital TV) and
ATV (Analogue TV) modes; however, some items are greyed
out in each case.
B
To use the options, press
move up and down through them and Q, and then, press
c
or to select the required choice. Follow the on-screen
instructions. The functions of each menu are described in
detail throughout the manual.
ORANGE LED - Programme
timer set (digital only)
RED LED – Programme
timer Active (digital only)
GREEN LED – On Timer set
!
(POWER) button on the
1
on the remote control, it may
1
on the remote
1
again. The picture may
on the navigation ring on the
b
and on the remote control to
RED LED – Standby
GREEN LED – Power on

Using the controls and connections

To alter the volume press –
To alter the programme position press
I i
Press MENU and ,
options.
Press MENU to finish.
An S-video cable provides better picture performance than a
composite video cable. If you connect an S-video cable to
EXT 3, be sure to disconnect the standard (composite) video
cable or the picture performance will be unacceptable.
To select an external input, press
input source is selected as described on page 39.
Please always refer to the owner's manual of the equipment to
be connected for full details.
NOTE: Interactive video games that involve shooting a "gun"
type of joystick at an on-screen target may not work with this
TV.
C
10
Standby
COMMON INTERFACE
The Common Interface is for a
Conditional Access Module
(CAM).
Contact a service provider.
USB port
To access photo
files
HDMI 4 INPUT
(Not available on
all models.)
INPUT 3
(EXT 3)
2
+.
b p B
.
U u
, or to control the sound and picture
o
until the appropriate