Table 7-1: Types Ofz - Teledyne 6400A Instruction Manual

TAI Model 6400A SO
Table 7-1: Types of Zero/Span Checks and Calibrations
Section Type of Cal or Check
7.1 Manual Z/S Check - Cal gas
through sample port
7.2 Manual Z/S Check or Calibration
with Z/S valve Option
7.3 Manual Z/S Check or Calibration
with IZS Option
7.4 Automatic Z/S Check with Z/S
Valves or IZS Option
7.5 Dynamic Z/S Calibration with Z/S
Valves or IZS Option
7.6 Calibrate using SO
Tube
7.7 Use of Z/S Valve or IZS with
Remote Contact Closure
7.8 EPA Protocol Calibration
7.9 Special calibration requirements
for Dual Range or Auto Range
7.10 Calibration Quality
7.11 References
Analyzer Operator Manual, 02164, Rev. G
2
Description
This calibration option expects the calibration gas
coming in through the sample port. IZS and
Zero/Span valves do not operate.
How to operate Zero/Span Valve Option.
Can be used to check or adjust calibration.
How to operate IZS Option. Can be used to check or
adjust calibration.
Operates Z/S valves or IZS once per day to check
the calibration.
Operates Z/S valves or IZS once per day and adjusts
the calibration.
Permeation Allows calibration using SO
2
permeation tube.
Operates Z/S valves or IZS with rear panel contact
closures. Without valves or IZS, can be used to
switch instrument into zero or span cal mode. Used
for either checking or adjusting zero/span.
Covers methods to be used if data is for EPA
SLAMS monitoring.
Covers special requirements if using Dual Range or
Auto Range.
Information on how to determine if the calibration
performed will result in optimum instrument
performance.
Contains a list of references on quality control and
calibration.
7-2
gas from the IZS
2