Variables Commands And Messages; Table 6-16: Rs-232 O - Teledyne 6400A Instruction Manual

TAI Model 6400A SO

6.8.8 VARIABLES Commands and Messages

Table 6-16: RS-232 Operating Modes
Mode
ZERO CAL A
ZERO CAL R
ZERO CAL M
SPAN CAL A
SPAN CAL R
SPAN CAL M
M-P CAL
DIAG ELEC
DIAG OPTIC
DIAG AOUT
DIAG
DIAG I/O
DIAG RS232
DIAG ERASE
SETUP x.x
SAMPLE A
SAMPLE
The 6400A operational modes are listed above. To list the analyzer's current mode type:
V MODE
See Table 6-14 for list of operational modes and meanings.
Model 6400A Internal Variables
The 6400A has a number of internal setup variables. Essentially all of these are set at time of
manufacture and should not need to be changed in the field. A list of user accessible variables is
shown in Table 9-5.
Analyzer Operator Manual, 02164, Rev. G
2
Description
Automatic zero calibration
Remote zero calibration
Manual zero calibration
Automatic span calibration
Remote span calibration
Manual span calibration
Manual multi-point calibration
Electrical diagnostic test
Optical diagnostic test
D/A output diagnostic test
Main diagnostic menu
Signal I/O diagnostic
RS232 output diagnostic
Memory erase diagnostic
Setup mode (x.x is software version)
Sampling; automatic cal. enabled
Sampling; automatic cal. disabled
Lists 6400A current operational mode
6-24