Table 6-7: Rs-232 C - Teledyne 6400A Instruction Manual

Sulfur dioxide analyzer
Table of Contents

Advertisement

TAI Model 6400A SO
Table 6-7: RS-232 Command Summary
Commands
?
T SET ALL
T SET name
T LIST [ALL]
T name
T CLEAR ALL
W SET ALL
W LIST [ALL]
W name
W CLEAR ALL
C command
D LIST
D name
D name=value
D LIST NAMES
D ENTER name
D EXIT
D RESET
D RESET RAM
D RESET EEPROM
V LIST
V name
V name=value
V CONFIG
Analyzer Operator Manual, 02164, Rev. G
2
Definition
Print help screen
Enable display of all test variables during T LIST
Display only NAME during T LIST
Print all test variables enabled with T SET or ALL
warnings
Print single test, "name" from Table 6-9
Disable T LIST, use with T SET name
Enable display of all warnings during W LIST
Print warnings enabled with W SET or ALL warnings
Print individual "name" warning from Table 6-10
Disable W LIST, use with W SET
Execute calibration "command" from Table 6-12
Prints all I/O signal values
Prints single I/O signal value/state
Sets variable to new "value"
Lists diagnostic test names
Enters and starts 'name' diagnostic test
Exits diagnostic mode
Resets analyzer(same as power-on)
System reset, plus erases RAM. Initializes DAS, SO
readings, calibration data not affected
System reset, plus erases EEPROM (RAM_RESET
actions + setup variables, calibration to default values)
Print all easy variable names from Table 9-5
Print individual "name" variable
Sets variable to new "value"
Print analyzer configuration
6-14
conc
2

Advertisement

Table of Contents
loading

Table of Contents