Teledyne 6200A Manual page 62

TAI Model 6200A SO
4.2.5.2 Status LED's
At the right of the display there are 3 status LED's. They can be in three states, OFF, ON, and
Blinking. The meanings of the LED's are given in Table 4-2.
Table 4-2: Front Panel Status LED's
LED
Green
Yellow
Red
Analyzer Operator Manual, 02164, Rev. G
2
Figure 4-2: Front Panel Display
State
Off
On
Blinking
Off
On
Blinking
Off
Blinking
(1) This occurs during Calibration, DAS holdoff, Power-up Holdoff, and when
in Diagnostic mode.
4-7
Meaning
NOT monitoring, DAS Disabled or inactive
Monitoring normally, taking DAS data
Monitoring, DAS in HOLDOFF mode (1)
Auto cal. disabled
Autocal. Enabled
Calibrating
Warnings exist
No warnings exist