Calibration And Zero/Span Checks - Teledyne 6200A Manual

TAI Model 6200A SO

7 CALIBRATION AND ZERO/SPAN CHECKS

There are several ways to check and adjust the calibration of the 6200A. These different methods are
summarized in the following Table 7-1. In addition, all of the methods described in this section can
be initiated and controlled via the RS-232 port, see Section 6.8 for details.
If you are using the 6200A for EPA monitoring, it is recommended to follow the
calibration method described in Section 7.8. All other calibration methods,
except in Section 7.6, are also applicable to EPA SLAMS if calibrated under
procedures refer to Section 9.2.8 and 9.2.9 – Unable to Span or Zero
Analyzer Operator Manual, 02164, Rev. G
2
the proper conditions as explained in Section 7.8.
If there are any problems completing any of the following
NOTE
NOTE
7-1