Table of Contents
Advertisement
1
Plug the power cord into a 230-240 V,
grounded (3-prong) AC outlet.
Press the power switch to turn on the
power.
2
Connect the handset cord to the handset
3
and the machine as shown.
Theends of the handset cord are iden-
d"
tical, so they will go into either jack.
Place the handset on the handset rest.
3
Plug the F080TP adaptor into the tele-
phone jack on the wall. Insert the small
modular plug which terminates
the
adaptor line cord into the jack on the
back of the machine mar'ketedTEL. LINE.
4
Adjust the volume switches on the left
side of the machine:
c RINGING VOLUME: Set the switch at
high (H), medium (M), or low (L) as
desired.
" SPEAKER VOLUME: Adjust
the
setting from high (H) to low (L) as
RINGING
SPEAKER
VOLUME
VOLUME
DIAL
HML
mm'ti
desired.
Set the mode of dialing with the DIAL
switch. Select "T" if you are on a touch-
tone line, or "P" if you are on a pulse dial
1
I
(rotary) line.
. Be sure to make the correct setting, or
you will not be able to make a call.
~ WARNING NOTICE: For all units installed in New Zealand, only
I the Tsetting for tone dialling is permitted. The P setting for pulse
I dialling does not operate properly and must not be used.
5
Mount the document support.
Slide the hook-shaped
ends of the
support onto the two studs on the rear
of the machine as shown.
INSTALLATION
2-3
Advertisement
Table of Contents
