Fisher-Price POWER WHEELS 74340 Owner's Manual & Assembly Instructions page 17

28
PUSH
HERE
Side
Fender
PULL HERE
• Fit the sport bar and sport bar support legs into the holes
in the vehicle body.
• Push down firmly on a sport bar side leg while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
29
Rear
Wheel
Well
1 1 / " x 1 / " Screw
2 4
• Insert a 1 1 / " x 1 / " machine screw into the hole closest to
2 4
the front of the vehicle in the underside of the rear wheel
well, through the vehicle body and into the end of the
sport bar.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure on the other side of the
vehicle body.
Assembly
Sport Bar
Sport Bar
30
Taillight
Housing
Taillight
Lens
#8 x 1" Screws
• Using safety scissors, remove the taillight lenses and the
taillight housings from the plastic connectors. Dispose of
the plastic connectors.
• Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
• Position the taillight housing with lens against the vehicle
body with the screw holes aligned, as shown.
• Insert two #8 x 1" screws through the taillight lens and
housing and into the vehicle body as shown.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other taillight.
31
• Position the gas cap so that its tether points down.
• Snap the gas cap into the hole under the right taillight.
17
Gas Cap
Tether