appear here and reserves the right to make changes without notice. ION is a registered trademark of Power Measurement Ltd. All other trademarks are property of their respective owners. Revision Date: June 3, 2003
9200 Power Supply
This document discusses the installation and specifications for the following
(if you are replacing an existing power supply). Fit the power supply plug-in connector to the meter plug-in port. All 9200 power supply models are installed the same way; the diagram for the 480V power supply is included to show the greater depth dimension of that model.
9200 Power Supply Retrofit Instructions Wiring the Power Supply Wiring the Power Supply The meter requires a constant power supply to maintain monitoring, analysis, control, and communications operations. Powering the device from the voltage source it is monitoring is not suitable for applications where these operations must be maintained in the event of a power outage.
Wiring the 480V Power Supply 9200 Power Supply Retrofit Instructions Wiring the 480V Power Supply Use18 to 14 AWG (0.8mm to 2.1mm ) wires Use18 to 14 AWG (0.8mm to 2.1mm ) wire Connections to the L1 and L2 terminals...
9200 Power Supply Retrofit Instructions Specifications Specifications Maximum Steady State Dielectric Power Supply Rated Inputs Meter Withstand Integrated AC: 100 – 240 VAC, 50 – 60 Hz Standard AC / DC DC: 110 – 300 VDC 2000 VAC RMS, TRAN / RMD Power Supply Installation category II (Local).