Seagate BARRACUDA 50 Installation Manual page 32

30
ST150176LC installation
1. Set the SCSI ID on the drive.
Determine which SCSI IDs are already being used in the
system and then assign the disc drive a SCSI ID that isn't
already being used. Use the J6 connector located on the
front of the drive to set the SCSI ID (see Figure 12).
step because the system automatically assigns the drive
SCSI ID.
• The host system's SCSI controller usually uses SCSI ID 7
so this SCSI ID is not usually available for disc drives or
other devices.
• Most ST150176LC drives are factory set with the SCSI ID
set at 0. If this is the only SCSI drive in your system and
there are no other SCSI devices on the daisychain, you can
leave this drive's SCSI ID set to 0 and proceed to the next
step. A device is any hardware other than an inline termina-
tor that is connected to the SCSI cable.
Barracuda 50 Installation Guide, Rev. A
• This drive is SCAM (SCSI Configured Auto Mat-
ically) compliant. If you are installing this drive in
a SCAM compliant system, you can skip this