Fisher-Price Ocean Wonders Aquarium Bouncer 79030 Instruction Sheet

Ocean wonders
Hide thumbs Also See for Ocean Wonders Aquarium Bouncer 79030:

Advertisement

Aquarium Bouncer
Model Number: 79030
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
Requires one "D" (LR20) alkaline battery (not included)
for soother operation; three "D" (LR20) alkaline
batteries (not included) for toy bar operation.

Advertisement

Table of Contents
loading

Summary of Contents for Fisher-Price Ocean Wonders Aquarium Bouncer 79030

  • Page 1 Aquarium Bouncer ™ Model Number: 79030 Please keep this instruction sheet for future reference, as it contains important information. Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included). Requires one “D” (LR20) alkaline battery (not included) for soother operation; three “D” (LR20) alkaline...
  • Page 2: Consumer Information

    Usually, we can solve the problem over the telephone or send you replacement parts. Please call Fisher-Price® Consumer Relations, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470.
  • Page 3 Parts Removable Teether Rings #8 x " Screw - 2 Shown Actual Size Toy Bar 2 Retainers Footrest with Electronic Unit Base Tube Right Base Wire Seat Back Tube Left Base Wire...
  • Page 4: Battery Installation

    Battery Installation Soother Battery Compartment • Locate the electronic unit on the footrest wire. You will see that there are two battery compartments. The smaller battery compartment the soother; the larger battery compartment • First, loosen the screw in the soother battery compartment door with a Phillips screwdriver.
  • Page 5: Battery Tips

    Battery Tips • Do not mix old and new batteries. • Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Remove the batteries during long periods of non-use. Always remove exhausted batteries from the toy. Battery leakage and corrosion can damage this product.
  • Page 6 Assembly This package contains small parts in its unassembled state. Adult assembly is required. • Place the base tube on a flat surface as shown. • Position the left and right base wires as shown. Note the location of the colored tab on the left and right base wires.
  • Page 7 Assembly Electronic Unit Battery Compartment Doors Up • Position the footrest so that the electronic unit battery compartment doors are upright. • While flexing the base wires toward each other, hook the footrest onto the ends of the base wires. •...
  • Page 8 Assembly IMPORTANT! You MUST position the seat back tube correctly for proper assembly of this product! Seat Back Tube Bends Backward Circles Match • Position the seat back tube so that it bends backward. • Match the colored symbol on the seat back tube to the colored symbol on the base wire ( circles on one side and colored symbols do not match, turn the seat back tube over and try again! •...
  • Page 9 Assembly • Fit a retainer (rounded side inward) to one end of the seat back tube. • Insert a screw through the outside hole in the seat back tube and into the retainer. • While holding the retainer in place, tighten the screw with a Phillips screwdriver.
  • Page 10 Assembly • Check to be sure the seat back tube bends backward. • Pull the seat back tube up to be sure it is secure. • If the seat back tube does not bend backward or you can remove either end of the seat back tube, you have not assembled it correctly.
  • Page 11 Assembly Footrest • Unbuckle the restraint belts from the restraint pad. Push the restraint belts back through the slots in the pad • Fit the pad upper pocket onto the seat back tube • Lift the footrest. Fit the pad lower pocket onto the footrest Lower the footrest.
  • Page 12 Assembly Restraint Belts • Fit both restraint belts back through the pad slots, as shown.
  • Page 13 Assembly • Insert and “snap” the ends of the toy bar into the sockets in the footrest. Hint: The square end of the toy bar fits into the square socket and the circular end of the toy bar fits into the circular socket. •...
  • Page 14: Setup And Use

    Set-Up & Use To prevent serious injury and/or falls: • Never use on any elevated surface, since child’s movement may cause bouncer to slide or tip over. • Never use as a carrier or lift while child is seated. • Always use the restraint system. •...
  • Page 15 Set-Up & Use Anchored End Free End Tighten To tighten the belts: • Feed the anchored end of the belt up through the buckle to form a loop • Pull the free end of the belt • Repeat this procedure to tighten the other belt. To loosen the belts: •...
  • Page 16 Set-Up & Use Baby Activated Bat Toys for Sounds or Music, Bubbling Action and Lights • Slide the mode switch to • When baby bats either toy, baby is rewarded with wave sounds, bubbling action and lights. Hint: Each time baby bats either toy, baby is rewarded with a different sound and light pattern! Note that the sound selection button does not work in baby activated mode.
  • Page 17 Set-Up & Use Parent Activated • Slide the mode switch to 10 minutes of music, lights and bubbling action. • Select music, or sounds, or no sound at all. Push the sound selection button again and again for: Lullabies Ocean Waves Summer Rain Babbling Brook No Sound...
  • Page 18 Set-Up & Use Teethers • The teethers are removable from the toys on the toy bar. Simply twist the ends of each teether slightly to remove from either toy. • To replace a teether, simply push to attach it to the bottom of either toy.
  • Page 19 Set-Up & Use Latch Remove the Toy Bar • Pull the ends of the latches out and lift the toy bar. Care The pad is machine washable. Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly.
  • Page 20: Fcc Note (United States Only)

    3121 Australia. Consumer Advisory Service 1300 135 312. New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©2002 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

Table of Contents