WARNING Prevent serious injury or death from falls or sliding out: • Always use the restraint system for the upright and reclined positions of the seat. Adjust restraint to fit your child snugly. The tray is not designed to hold the child in the chair.
Page 3
Parts Food Tray Footrest Snack Tray Seat Back with Shoulder and Waist Belts 2 Front Legs 2 Back Legs Seat Bottom with Crotch Belt 2 Seat Brackets Back Base Front Base Seat Pad Allen Wrench M4 x 17mm Screw – 6 M5 x 59,5mm Screw –...
Page 4
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price for replacement parts and instructions if needed. Never substitute parts.
Page 5
Front Leg • Position a front leg so that it curves up and fit it into the small socket in the seat bottom. Hint: If the leg does not seem to fit into the seat bottom, try the other front leg. •...
Back Base M6 x 28mm Screws M6 x 28mm • Fit the back base onto the bottom of both back legs, as shown. • Insert two M6 x 28mm screws into each back leg and tighten. M6 x 28mm Screws Front Base Front Legs •...
Page 7
Seat Back Holes • At an angle, fit the pegs on each side of the seat back into the holes in the sides of the seat bottom. Hint: You may need to flex the bottom edge of the seat back to fit the seat back pegs into the holes in the seat bottom.
Page 8
M4 x 17mm Screws • Fit the other seat bracket to the other side of the seat bottom, as shown. • Insert two M4 x 17 mm screws and tighten. • Unbuckle the lower restraint. Assembly Seat Bracket Shoulder Belt Hint: The shoulder belts come assembled to the seat back in the lower position for a smaller child.
Page 9
Elastic Loops Slots • Fit the elastic loops on the seat pad down through the slots in the footrest. Pegs BACK VIEW • Fit the elastic loops on the seat pad bottom onto the pegs on the footrest. Assembly Shoulder Belts •...
WARNING Prevent serious injury or death from falls or sliding out: • Always use the restraint system for the upright and reclined positions of the seat. Adjust restraint to fit your child snugly. The tray is not designed to hold the child in the chair.
Page 11
• Tighten each waist belt/shoulder belt so that the restraint system is snug against your child. Please refer to the next section for instructions to tighten the waist belts/shoulder belts. Securing Your Child Adjuster • To tighten the waist belts: Feed the anchored end of the waist belt up through the buckle to form a loop the waist belt •...
Page 12
• Unbuckle the restraint system. Shoulder Belts • To adjust the restraint height for baby, push to remove the shoulder belts from the seat back. Securing Your Child Shoulder Belts Restraint System Larger Baby • Insert the ends of the shoulder belts through the upper slots in the pad and seat back.
PULL Adjusting Seat Height • Pull the levers on both seat height adjusters and lift or lower the seat to any of five different heights. • Make sure both sides of the seat are adjusted to the same height. • Push the seat bottom to be sure the seat is secure.
Page 14
Hint: Before use, thoroughly wash all parts (the trays) that may contact food. The snack tray is not dishwasher safe. Armrests Snack Tray • Slide the snack tray onto the seat armrests. Push the snack tray until it "snaps" into place. Food Tray •...
Page 15
Storage • Push down on the levers on the back legs. • Then, push the back legs in towards the front legs. • The snack tray, seat and restraint straps may be wiped clean using a mild cleaning solution and damp cloth. Do not use bleach. Do not use harsh or abrasive cleansers.