Advertisement
61. Attach the Press Cable (72) to the remaining "U"-
Bracket (33) with a 1/4" Washer (99) and a 1/4"
Nylon Locknut (103). Note: Do not completely
tighten the Nylon Locknut; it should be
threaded only two turns onto the end of the
Cable, as shown in the inset drawing.
Attach the "U"-Bracket (33) to the Long Weight
Tube (43) with a 5/16" x 1 3/4" Bolt (96) and a
5/16" Nylon Locknut (86).
Important: Follow all five cables from end to
end and make sure that they rest in the
grooves of all of the pulleys and that the
cables and the pulleys move smoothly•
Seat Assembly
62. Locateandopenthepartsbaglabeled"SEAT
ASSEMBLY."
Attach the Butterfly Backrest (25) to the Butterfly
Upright (4) with two 1/4" x 2 1/2" Bolts (79) and
two 1/4" Washers (99).
63. Insert a 1/4" x 2 1/2" Carriage Bolt (91) through
the center hole in a Seat Plate (30). Attach the
Seat Plate to a Seat (23) with two 1/4" x 3/4" Bolt
(98).
Insert the 1/4" x 2 1/2" Carriage Bolt (91) into the
indicated hole in the Butterfly Seat Frame (10)
and secure it with a 1/4" Washer (99) and a 1/4"
Nylon Locknut (103). Secure the other end of the
Seat (23) with a 1/4" x 2 1/2" Bolt (79) and a 1/4"
Washer.
Attach the other Seat (23) to the Press Seat
Frame (12, not shown) in the same manner.
64. Insert a 1/4" x 2 1/2" Carriage Bolt (91) through
the center hole in a Seat Plate (30). Attach the
Seat Plate to the Press Backrest (24) with two
1/4" x 3/4" Bolt (98).
Insert the 1/4" x 2 1/2" Carriage Bolt (91) into the
indicated hole in the Press Upright (5) and secure
it with a 1/4" Washer (99) and a 1/4" Nylon
Locknut (103). Secure the other end of the Press
Backrest (24) with a 1/4" x 2 1/2" Bolt (79) and
another 1/4" Washer.
61
, L
72--41
62
63
25½
99
64
99
23
Hide quick links:
Advertisement
