Advertisement
49. Wrap the Press Cable (72) around a 3 1/2" Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the indicated hole in the
Press Upright (5) with a 3/8" x 3 3/4" Bolt (101), a
3/8" Washer (97) and a 3/8" Nylon Locknut (90).
Make sure the Cable Trap is positioned to hold
the Cable in the groove of the Pulley,
50. Route the Press Cable (72) through the opening
in the Press Frame (17) and wrap the Cable
around a 3 1/2" Pulley (35) in the direction
shown.
Attach the 3 1/2" Pulley (35) and a Cable Trap
(38) to the indicated hole in the Press Frame (17)
with a 3/8" x 3 1/4" Bolt (104), a 3/8" Washer (97)
and a 3/8" Nylon Locknut (90). Make sure the
Pulley is attached on the inside of the Press
Frame, Make sure the Cable Trap is positioned
to hold the Cable in the groove of the Pulley,
51. Wrap the Press Cable (72) around a "V"-Pulley
(34) in the direction shown. Attach the Pulley and
a Long Cable Trap (37) to the small tube on the
Press Upright (5) with a 3/8" x 3 1/4" Bolt (104), a
3/8" Washer (97) and a 3/8" Nylon Locknut (90).
Note: The small tube has four adjustment
holes. Attach the "V"-Pulley
in the hole far-
thest from the Upright. Make sure the Cable
Trap is oriented as shown.
52. Wrap the Press Cable (72) around a 3 1/2" Pulley
(35) in the direction shown. Attach the Pulley to
the indicated hole in the Press Frame (17) with a
3/8" x 3 1/4" Bolt (104), a 3/8" Washer (97), and a
3/8" Nylon Locknut (90). Make sure the Pulley is
attached on the inside of the Press Frame.
Make sure the Cable Trap is positioned to
hold the Cable in the groove of the Pulley.
51
101
ff
2O
Hide quick links:
Advertisement
