BATTERY CHARGING
E
Battery
• Plug the charger connector into the battery
• Plug the charger into a standard wall outlet
Note: If power flow to the wall outlet is controlled by a switch, make
sure the switch is "ON".
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, pull firmly on the charger connector
to disconnect it from the battery. Unplug the charger from the wall
outlet. The battery is now ready to be installed in your vehicle.
Please see the Battery Installation section on page 18 for detailed
instructions on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the motor harness
connector to the battery. Lower and fasten the hood.
8
B
A
Charger
Connector
.
A
.
B
ASSEMBLY
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery, or
help in assembly of the vehicle.
B
A
1
A
• Position the dash on the vehicle.
• Make sure the motor harness connector wire is through the groove
in the dash.
" screw through each of the two corner dash tabs
• Insert a #10 x
1
/
2
nearest to the passenger compartment
• Insert a #10 x 1" screw through the two dash tabs nearest to the
battery compartment
.
B
• Insert a #10 x 1" screw into the hole in the center of the dash
• Tighten the screws.
B
B
A
Dash
Motor
Harness
Connector
Wire
B
.
A
B
H3427a-0920
F
.
Comments to this Manuals
Latest comments: